Dual UVS10W In-Car Phone Sanitizer with Wired and Wireless Phone Charging Owner’s Manual
- June 7, 2024
- Dual
Table of Contents
UVS10W
OWNER’S MANUAL
In-Car Phone Sanitizer with Wired and Wireless Phone Charging
Powerful Sanitizing in just 5 Minutes
Using the Sanitizer
Place your phone
in the sanitizer, centered on the four plastic legs, and close the lid. Press
the button on the top of the lid to sanitize and the light will turn Red. The
light will turn off when complete after 5 minutes.
A magnetic switch in lid prevents the unit from turning on when open.
Your phone will be bathed by 8UV-CLED’s to completely clean all the surfaces.
Powering Up the Sanitizer
Product Information
-
Power Button
– Light will turn Blue while charging
– Light will turn Red when sanitizing -
Wireless Charging Area
-
USB-C Power Cable Input (cable included)
Use the supplied USB-C cable and 12V adapter for in-car use.
Use your USB
power adapter to power the sanitizer for in-home use.
Wired and Wireless Charging
Wireless Charging
(with compatible phones)
Place your mobile phone in the center of the charging area.
Blue light= charging.
Blue light off = fully charged.
Blue Blinking= Remove non-chargeable object from the top of wireless charger.
(Phone cases thicker than 3mm may need to be removed for wireless charging.)
Wired
Charging
Plug your phone charging cable into the 12V adapter and place your phone
inside the sanitizer. To also sanitize while charging, close the lid and
press the button on top.
One-Year Limited Warranty
This warranty gives you specific legal rights. You may also have other rights
which vary from state to state. Dual Electronics or. warrants this product to
the original purchaser to be free from defects in material and workmanship for
a period of one year from the date of the original purchase. Dual Electronics
Corp. agrees, at our option, during the warranty period, to repair any defect
in material or workmanship or to furnish an equally new, renewed, or
comparable product (whichever is deemed necessary) in exchange without
charges, subject to verification of the defect or malfunction and proof of the
date of purchase. Subsequent replacement products are warranted for the
balance of the original warranty period. Who is covered? This warranty is
extended to the original retail purchaser for products purchased from an
authorized Dual dealer and used in the U.S.A. What is covered? This warranty
covers all defects in material and workmanship in this product. The following
are not covered: software, installation/removal costs, damage resulting from
accident, misuse, abuse, neglect, product modification, improper installation,
incorrect line voltage, unauthorized repair or failure to follow instructions
supplied with the product, or damage occurring during return shipment of the
product. Specific license conditions and copyright notices for the software
can be found via www.dualav.com.
What to do?
- Before you call for service, check the troubleshooting guide in your owner’s manual. A slight adjustment of any custom controls may save you a service call.
- If you require service during the warranty period, you must carefully pack the product (preferably in the original package) and ship it by prepaid transportation with a copy of the original receipt from the retailer to an authorized service center.
- Please describe your problem in writing and include your name, a return UPS shipping address (P.O. Box not acceptable), and a daytime phone number with your shipment.
- For more information and for the location of the nearest authorized service center please contact us by one of the following methods:
– Call us toll-free at 1-866-382-5476 (Monday-Friday, 9.00 am, to 500 pm, EST) or E-mail us at cs@dualav.com
Exclusion of Certain Damages: This warranty is exclusive and in lieu of any and all other warranties, expressed or implied, including without limitation the implied warranties of merchantability and fitness for a particular purpose and any obligation, liability, right, claim or remedy in contract or tort, whether or not arising from the company’s negligence, actual or imputed. No person or representative is authorized to assume for the company any other liability in connection with the sale of this product. In no event shall the company be liable for indirect, incidental or consequential damages.
FCC Compliance
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions:
- this device may not cause harmful interference, and
- this device must accept any interference received, including interference that may cause undesired operation.
Specifications and Features
General
Dimensions:9.3″ (W) x 5.7″ (D) x2.3″ (H)
Weight: 1.6 lbs.
Color: Gray
Materials: ABS+PC (plastics) and Silicon Pad
12V Power Adapter: 5V/2A
USB-C Charging Cable Length: 4.9t.
Certificates: FCC, RoHS
Operating temperature from -4° F to 158° F
Wireless Charger Specifications
Wireless Charger Output:
- Apple devices up to 7.5W
- Android devices up to 1 OW
The charging current will automatically adjust the power according to the requirements of the mobile phone. Once the phone is fully charged the wireless charger will automatically switch off.
Specifications
Input Voltage: 5V, 9V, 12V Wireless
Charging output: 5W. 7.5W. 10W. 15W
UV Sanitizer
UV-C LED (8 TOTAL): Broad Beam Sterilizing with 160° Dispersion per LED at
230nm-280nm wavelength.
Sanitizing Time: Push sanitizer button once – 5 minutes.
Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communi cations. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following.
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Contact us for help
Ultraviolet (UV) light may cause eye damage.
Do not look directly at the light. If you experience any discomfort or pain,
stop using the UV Sanitizer and contact your physician.
SAVE THESE INSTRUCSTIONS
Dual Electronics Corp.
Toll-Free: 1-866-382-5476
Monday-Friday, 9 AM-5 PM EST
www.dualav.com
©2020 Dual Electronics Corp.
All rights reserved.
NSA0720
Printed in China
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Any changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help.
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment. This equipment should be installed and operated with
a minimum distance of 20cm between the radiator & your body.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>