Electric Rides Electric scooter User Manual

Electric Rides Electric scooter

SAFETY INSTRUCTIONS

• An electric scooter is sporting entertainment tool that is not a vehicle, but one you drive it into a public area, it will also have a vehicle property, so there are also possible
  safety risks for all modes of transport. Strictly follow the instructions in this manual to drive for the maximum extent to protect you and the others’ safety, and to ensure compliance with national and provincial traffic regulations and traffic regulations.

• At the same time, you need to understand: Once you have an electric scooter on a public road or other public place, you may be exposed to the risk of unauthorized
  driving/improper operation of others or vehicles, even if you are in full compliance with bthis safe driving guide. Like walking or cycling may also be hurt by other meas of transport. As with all vehicles, the faster the electric scooter is driving, the longer the brakes need, and the emergency brakes on some smooth surfaces can also cause
  the wheel to slip and lose balance or even fall. Therefore, it’s important to be vigilant and maintain the proper speed during driving, and it’s important to maintain a reasonable safety distance with others and the transport means. Please be vigilant and drive at low speed before entering unfamiliar terrain.

• Please respect the right of pedestrian way when driving. Avoid frightening pedestrains, especially the children. When pedestrians passing through, remind pedestrians and slowing down when passing. As far as possible from the left side of the pedestrian( applicable to the country where the vehicle is traveling right). Face to face with pedestrians, keep on the right and lower speed.

• We must strictly follow the safety requirements of this manual for drivers in countries and regions, where there are no national standards and regulations for electric scooters, such as in China. We shall not be liable for any liability, personal injury, accident, legal dispute, and all other unfavorable events resulting from the use of violation the instructions indicated in this manual.

• Do not lend the electric scooter to a person who does not operate to avoid injury. If give the electric scooter to a friend, be sure to be responsible for the safety of your friends, you should teach him(her), and tell him (her) must wear safety care.

• Please check the electric scooter for each time before driving. If you find the parts are loose, the battery life is obviously reduced, the tire is slow to leak or excessive wear, turn to abnormal sound or malfunction, please stop using it immediately, and do not driving force.

Product and Parts

Functional Sketch

Body Assembly

1. Secure the scooter standpipe and open he kickstand.
2. Install the crossbar on the standpipe.
3. Use the hex wrench in the packing box to lock the screws on both sides.
4. After installation, long press the button to turn on the machine.

Operation

Wear helmet and other protective gears to avoid any possible injury while riding.

1. Turn on the power and check the power indicator.
2. Scooter boosting: slide the scooter with your foot 1-2 meters, then press the accelerator for running.
3. To slow down: simply release the throttle button, use the brake handle on  the left for stronger braking
4. To change direction: lean slightly to the left or right and turn the handlebars slightly.

To fold: Make sure that the electric scooter is turned off, open the pole lock, push down the base pole and fix the folding hook to the folding lock.
To unfold: Press the folding hook to release and follow the folding step reversely to unfold the E-scooter.

Adjusting the brake:

1. Use the M5 hex wrench anticlockwise to release the plate screws on back wheel, adjust the length of exposed tail, shorten for tightening and lengthen for loosing the brake.
2. Lock the pressure plate screws by rotating clockwise.

Fix the handle:

If your standpipe in the electric scooter is shaking, please use the M5 hex wrench to lock the two screws at the folding mechanism.

Inflate the tires:

1. Remove the front and rear tire inflatable mouth cap.
2. Connect the pump to inflate and tight it to the inflatable mouth.
3. Replace the mouth cap when finish pumping.

Model Parameter table

Care / Maintenance
Cleaning
If stains appear on the surface of your scooter, rub them with a soft and damp cloth. In case of stubborn stains, you can first scrub with a soft cloth soaked in toothpaste, then rub with a soft, damp cloth. Never clean with alcohol, gasoline or other corrosive or volatile chemical solvents. This may damage the appearance and structure of the vehicle. It is also forbidden to use a pressure washer to clean your scooter, you may be subjected to electric shock or serious damage to your vehicle.
Storage
You must store your vehicle in a room away from heat and moisture. Prolonged exposure to the sun or heat can accelerate the aging of your scooter and shorten battery life.
Battery maintenance
Please do not expose the batteries to an environment higher than 50 ° C or lower than – 20 ° C (eg do not leave the battery in the trunk of your car), this could cause ignition of the batteries or significant damage to your drums. To prevent the battery from being discharged, try recharging it regularly and not waiting for it to discharge completely. To make the best use of battery life, it is recommended to use it at normal temperatures. Below 0 ° C, the battery life drops sharply. When the battery is full, charging is available up to 90-120 days in pause mode. If the battery is not full, charging is available up to 20-50 days in pause mode. It is important not to leave the discharged battery for too long as this could cause serious damage.

Read User Manual Online (PDF format)

Download This Manual (PDF format)

Download this manual  >>