Honeywell C7089R3013 RedLINK 3.0 Wireless Outdoor Sensor Installation Guide
- June 3, 2024
- Honeywell
Table of Contents
Home
C7089R3013
RedLINK® 3.0
Wireless Outdoor Sensor
Installation Guide
C7089R3013 RedLINK 3.0 Wireless Outdoor Sensor
If there is more than one T10+ thermostat:
Wireless devices must be linked separately to each T10+ thermostat.
RedLINK 3.0 Installation Guide (Wireless Outdoor Sensor)
Use C7089R3013 RedLINK 3.0 wireless outdoor sensor with compatible T10+
thermostat models
| T10+ Thermostats | Model Number |
|---|---|
| T10+ Thermostat with Indoor Sensor | THX321WFS3001W |
| T10+ Thermostat without Sensor | THX321WF3003W |
| T10+ Thermostat, EIM, RATS/DATS, Wireless Indoor Sensor | YTHM1004R3000 |
| T10+ Thermostat, EIM, RATS/DATS, OAS, Wireless Indoor Sensor | YTHM1004R3001 |
Install batteries in wireless outdoor sensor
Make sure batteries are inserted properly. (See polarity marks on illustration below.)
Link RedLINK 3.0 wireless outdoor sensor to T10+ thermostat
At T10+ thermostat:
- Open the menu.
- Tap Devices & Sensors.
- Tap Add.
- Follow the on-screen instructions.
Mount outdoor sensor
Mount the sensor on a vertical exterior wall, at least 6 inches below any overhang. Choose a location protected fromdirect sunlight.
Place sensor securely in bracket, facing away from wall.
Replacing outdoor sensor
At T10+ thermostat:
- Open the menu.
- Tap Devices & Sensors.
- Select Outdoor Sensor.
- Select Delete.
After the outdoor sensor has been deleted you can add a new outdoor sensor by selecting “Add” as shown on page 2.
Regulatory information
FCC Compliance Statement (Part 15.19) (USA only)
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions:
- This device may not cause harmful interference, and
- This device must accept any interference received, including interference that may cause undesired operation.
FCC Warning (Part 15.21) (USA only)
Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
FCC Interference Statement (Part 15.105 (b)) (USA only)
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one of the
following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Outdoor sensor
To comply with FCC and Industry Canada RF exposure limits for general
population/ uncontrolled exposure, the antenna(s) used for these transmitters
must be installed to provide a separation distance of at least 20 cm from all
persons and must not be co-located or operating in conjunction with any other
antenna or transmitter.
Section 7.1.5 of RSS-GEN
Operation is subject to the following two conditions:
- this device may not cause interference, and
- this device must accept any interference, including interference that may cause undesired operation of the device.
Need Help?
For assistance with this product please visit
http://customer.resideo.com or call Customer
Care toll-free at 1-800-468-1502
Resideo Technologies, Inc.
1985 Douglas Drive North, Golden Valley, MN 55422
1-800-633-3991
33-00604EFS—02 M.S. 01-22 | Printed in Mexico
www.resideo.com
© 2022 Resideo Technologies, Inc. All rights reserved.
The Honeywell Home trademark is used under license from Honeywell
International, Inc. This product is manufactured by Resideo Technologies, Inc.
and its affiliates.
References
- Resideo Customer Portal
- Smart Home Products and Systems | Resideo
- Smart Home Solutions in EMEA | Resideo
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>