Jabra Pro 920 Mono User Manual
- June 3, 2024
- Jabra
Table of Contents
Pro 920 Mono
User Manual
Pro 920 Mono
Jabra Pro 920 Mono
How to connect my Jabra PRO 92x with Nortel IP 1120E, 1140E, 1150E, 1165E
Prerequisite:
Jabra PRO 92x + Jabra LINK 14201-32
In combination with one of the following phones:
- Nortel IP 1120E
- Nortel IP 1140E
- Nortel IP 1150E
- Nortel IP 1165E
from Firmware release 3.1 for IP phones.
Connection:
- Connect the 1-sided end (USB plug) of the EHS adapter to the USB socket of your phone.
- Connect the RJ9 plug into the socket marked with the “phone” symbol and the RJ45 plug into the base socket marked with “AUX”.
Now you can setup the headset for your phone with the automatic or manual configuration.
Automatic configuration:
To start the automatic configuration, please let someone call you on this
phone; wait at least 10 seconds before you pick up the phone. Now the
appropriate EHS mode should be set up.
If the automatic configuration did not work, please manually select the DHSG
mode. See User Manual for instructions.
Base setup:
Set the phone setup switch to position “A”.
Microphone volume setup:
Put on the headset and call a colleague.
Now you can select the desired microphone volume using the +/- button.
Phone setup:
Press the “Service button” twice > Preset >Headsets > USB
In addition, you must activate the menu option “Enable HID Commands”, see
below.
References
- [FAQTitle] | Jabra Pro 920 Mono | FAQ | Jabra Support
- How to connect my Jabra Pro 92x with Nortel IP 1120E, 1140E, 1150E, 1165E | Jabra Pro 920 Mono | FAQ | Jabra Support
- [FAQTitle] | Jabra Pro 920 Mono | FAQ | Jabra Support
- How do I connect my Jabra headset with a Digium D40, D45, D50, D60, D62, D65, D70 or D80 desk phone so I have remote call control using my headset? | Jabra Pro 920 Mono | FAQ | Jabra Support
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>