NISBET ESSENTIALS DC439 Ice maker Instruction Manual

NISBET ESSENTIALS DC439 Ice maker Instruction Manual

Safety Instructions

• Position on a flat, stable surface.
• A service agent/qualified technician should carry out installation and any repairs if required. Do not remove any components on this product.
• Consult Local and National Standards to comply with the following:
  • Health and Safety at Work Legislation
  • BS EN Codes of Practice
  • Fire Precautions
  • IEE Wiring Regulations
  • Building Regulations
• DO NOT immerse in water, or use steam/jet washers to clean the unit.
• DO NOT cover the appliance when it is operating.
• Always carry, store and handle the appliance in a vertical position.
• ONLY use drinking or potable water when making ice cubes.
• Replace any unused water in the tank at least once every 24 hours.
• Keep all packaging away from children. Dispose of the packaging in accordance to the regulations of local authorities.
• This appliance can be used by children aged from 8 years and above and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning use of the appliance in a safe way and understand the hazards involved.
• Children shall not play with the appliance.
• Cleaning and user maintenance shall not be made by children without supervision.
• If the power cord is damaged, it must be replaced by a Nisbets Essentials agent or a recommended qualified technician in order to avoid a hazard.
• Nisbets Essentials recommend that this appliance should be periodically tested (at least annually) by a Competent Person. Testing should include, but not be limited to: Visual Inspection, Polarity Test, Earth Continuity, Insulation Continuity and Functional Testing.
• The appliance is intended to be used in household and similar applications.
• Nisbets Essentials recommend that this product is connected to a circuit protected by an appropriate RCD (Residual Current Device).

Warning: Risk of fire / flammable materials

• Do not store explosive substances such as aerosol cans with a flammable propellant in this appliance.
  Warning: Keep all ventilation openings clear of obstruction. Unit should not be boxed in without adequate ventilation.

• Warning: Do not use mechanical devices or other means to accelerate the defrosting process, other than those recommended by the manufacturer.

• Warning: Do not damage the refrigerant circuit.

• Warning: Do not use electrical appliances inside the food storage compartments of the appliance, unless they are the type recommended by the manufacturer.

Pack Contents

The following is included:

• Ice Maker
• Removable ice basket
• Ice scoop
• Instruction manual

Nisbets Essentials prides itself on quality and service, ensuring that at the time of packaging the contents are supplied fully functional and free of damage. Should you find any damage as a result of transit, please contact your Nisbets Essentials dealer immediately

Installation

Note: If the unit has not been stored or moved in an upright position, let it stand upright for approximately 12 hours before operation. If in doubt allow to stand.

1. Remove the appliance from the packaging and the protective film from all surfaces.
2. To optimize performance and longevity, ensure a minimum clearance of 2.5cm is maintained between the unit and walls and other objects, with a minimum 5cm clearance on the top.
   NEVER LOCATE NEXT TO A HEAT SOURCE.

WARNING: When positioning the appliance, ensure the supply cord is not trapped or damaged.
WARNING: Do not locate multiple portable socket-outlets or portable power supplies at the rear of the appliance.

Operation

Control Panel

Making Ice

Note: Before using for the first time, clean the water tank, ice basket and ice basket shelf. Use the first 3 ice making cycle to flush out the system. Discard the water and ice created from the first 3 cycles.

Each time the appliance is refilled, the first ice making cycle is used to reduce the water temperature.
This results in uneven ice cube production which is perfectly normal. You may wish to discard ice created in the first two production cycles.

1. Lift the access lid and fill the water tank up the level of the ice basket shelf.

2. Connect the appliance to the power and press the “POWER” button.
   Press the “SELECT” button repeatedly to scroll through the ice cube sizes. Stop when the required size is illuminated.
   Note: The ice making cycle will vary depending on the size of cube selected. Larger cubes will take longer to produce.

3. The appliance will run a start-up routine and then begin ice production.
   Note: If the water level is too low, the ADD WATER indicator lights up and the appliance stops working. Fill the water tank and the appliance will restart automatically.

4. When the cubes reach the ice sensor the appliance will stop production. Production resumes once ice has been removed.

Cleaning, Care & Maintenance

• Always switch off and disconnect the power supply before cleaning.

• Warm, soapy water is recommended for cleaning.
  Cleaning agents may leave harmful residues.
  DO NOT wash the base unit, instead wipe the exterior with a damp cloth.

• A Nisbets Essentials agent or qualified technician should carry out repairs if required.

• Clean the water filter regularly with a small brush, particularly in hard water areas. The water filter is located in the pump inlet at the bottom of the water tank, remove by pulling out with fingers.

• If the appliance is to be left unused for longer than 24 hours, loosen the drain screw and drain the water from the tank.

• The inner removable parts and water tank should be cleaned regularly.

Automatic cleaning

• Remove the ice basket. Then add dilute cleaner into the water tank. Note: Choose ice maker specific cleaner and follow the manufacturer’s instructions.
• Press the “CLEAN” button. The “CLEAN” indicator flashes and auto cleaning cycle starts. After autocleaning done, the “CLEAN” indicator will go out.
• Turn the unit off and disconnect from power supply. Loosen the drain screw to drain the solution.

Note: After auto-cleaning, use the first 3 ice making cycles to flush out the system. Discard the water and ice created from these initial cycles.

Troubleshooting

If your Nisbets Essentials appliance develops a fault, please check the following table before making a call to the Helpline or your Nisbets Essentials dealer.

Fault

| Probable Cause|

Solution

---|---|---
The appliance is not working| The unit is not switched on| Check the unit is plugged in correctly and switched on
Plug or lead is damaged| Call Nisbets Essentials agent or qualified Technician
Fuse in the plug has blown| Replace the plug fuse
Power supply| Check power supply
Appliance is noisy or works intermittently| Power fluctuations| Turn off the ice maker and restart after 3 minutes
O
ADD WATER| Add Water indicator is lit| Water level is low or tank is empty| Refill water tank and restart
Water filter is blocked| Clean water filter and restart appliance
O
ICE FALL| Ice Full indicator is lit| Ice basket full| Empty the ice basket
All indicators flash simultaneously| Water box is blocked by ice| Disconnect from the power supply. Remove some of the ice cubes and gently tilt the water box by hand. Restart the appliance after 3 minutes. If the unit fails to work after above operations, call Nisbets Essentials agent or qualified Technician
The motor stops working suddenly
Ice cubes are sticking together| Ice making cycle is too long| Reset the ice cube size and restart the appliance
Water tank temperature is too low| Empty water tank and refill
Compressor runs but no ice is made| Refrigerant leak or block in the refrigerant system| Call Nisbets Essentials agent or qualified technician

Technical Specifications

Model

| Voltage| Power| Bin Storage| Max. Ice Making Capacity| Refrigerant| Dimensions H x W x D mm| Weight
---|---|---|---|---|---|---|---
DC439| 220-240V~ 50Hz| 150W| 0.7kg| 20kg/24 hours| R600a| 327 x 270 x 365|

10.6kg

Electrical Wiring

Nisbets Essentials appliances are supplied with a 3 pin BS1363 plug and lead.
The plug is to be connected to a suitable mains socket.

Nisbets Essentials appliances are wired as follows:

• Live wire (coloured brown) to terminal marked L
• Neutral wire (coloured blue) to terminal marked N
• Earth wire (coloured green/yellow) to terminal marked E

This appliance must be earthed.
If in doubt consult a qualified electrician.
Electrical isolation points must be kept clear of any obstructions. In the event of any emergency disconnection being required they must be readily accessible.

Disposal

EU regulations require refrigeration product to be disposed of by specialist companies who remove or recycle all gasses, metal and plastic components.

Consult your local waste collection authority regarding disposal of your appliance. Local authorities are not obliged to dispose of commercial refrigeration equipment but may be able to offer advice on how to dispose of the equipment locally.

Alternatively call the Nisbets Essentials helpline for details of national disposal companies within the EU.

Compliance

The WEEE logo on this product or its documentation indicates that the product must not be disposed of as household waste. To help prevent possible harm to human health and/ or the environment, the product must be disposed of in an approved and environmentally safe recycling process. For further information on how to dispose of this product correctly, contact the product supplier, or the local authority responsible for waste disposal in your area.

Nisbets Essentials parts have undergone strict product testing in order to comply with regulatory standards and specifications set by international, independent, and federal authorities.

Nisbets Essentials products have been approved to carry the following symbol.

All rights reserved. No part of these instructions may be produced or transmitted in any form or by any means, electronic, mechanical, photocopying, recording or otherwise, without the prior written permission of Nisbets Essentials.

Every effort is made to ensure all details are correct at the time of going to press, however, Nisbets Essentials reserve the right to change specifications without notice.

DECLARATION OF CONFORMITY

Equipment Type

| Model
---|---
Ice maker – 20kg|

DC439 (& -E -A)

Application of Territory Legislation & Council Directives(s)

| Low Voltage Directive (LVD) – 2014/35/EU
Electrical Equipment (Safety) Regulations 2016

• EN 60335-1:2012 +A11:2014 +A13:2017
• EN 60335-2-24:2010 +A1:2019 +A2:2019
• EN 62233:2008

Electro-Magnetic Compatibility (EMC) Directive 2014/30/EU- recast of 2004/108/EC
Electromagnetic Compatibility Regulations 2016 (S.I. 2016/1091)

• EN 55014-1:2017
• EN 55014-2: 2015
• EN 61000-3-2: 2014
• EN 61000-3-3: 2013

Restriction of Hazardous Substances Directive (RoHS) 2015/863 amending Annex II to Directive 2011/65/EU
Restriction of the Use of Certain Hazardous Substances in Electrical and Electronic Equipment Regulations 2012 (S.I. 2012/3032)

| Electrical Safety

• IEC 60335-1:2010
• IEC 60335-2-24:2010 +A1:2012

Electromagnetic Compatibility

• EN 55014-1:2017
• EN 55014-2: 2015
• EN 61000-3-2: 2014
• EN 61000-3-3: 2013

Producer Name| Nisbets Essentials

the undersigned, hereby declare that the equipment specified above conforms to the above Territory Legislation, Directive(s) and Standard(s).

Date

| 18th June 2021
---|---

Signature

|

| |

Full Name

| Ashley Hooper| Eoghan Donnellan| Josie Holt

Position

| Technical & Quality Manager| Commercial Manager/ Importer| Commercial Manager/ Responsible Supplier

Producer Address

| Fourth Way,

Avonmouth,

Bristol,

BS11 8TB

United Kingdom

| 42 North Point

Business Park

New Mallow Road

Cork

Ireland

| 15 Bagdally Road,

Campbelltown

NSW 2560

http://www.nisbets.com/

References

• Nisbets Catering Equipment & Supplies | Commercial Catering Equipment

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>