Honeywell RPWL3045A Wireless Converter/Extender/Bell Push Instruction Manual

: June 7, 2024
: Honeywell

Table of Contents

Honeywell RPWL3045A Wireless Converter/Extender/Bell Push Instruction
Read User Manual Online (PDF format)
Download This Manual (PDF format)

Honeywell RPWL3045A Wireless Converter/Extender/Bell Push Instruction

Manual

This is a legacy product document supported by Resideo. It is no longer manufactured

Wireless Compatibility

What is included

Converter / Extender / Bell Push
CR2032 battery
Mounting hardware
Bell wire (for use with a wired push)

Safety

Always follow the manufacturer’s advice when using power tools and wear suitable protective equipment (e.g. safety goggles) when drilling holes etc. Before drilling holes in walls, check for hidden electricity cables and water pipes, the use of a cable/pipe locator may be advisable if in doubt.

Open the bell push/converter

Using a ball point pen press at point A shown in fig 1. Remove the cover. Undo the retaining screw B and remove the back of the push.

Fig. 1

To install the push/converter battery

Insert the CR2032 coin cell. Ensure the face marked ‘+’ is uppermost (Fig. 2).

Fig. 2

Bell push/converter functions

The bell push in this kit can be used as a stand-alone wirefree push. Additionally, it can be used to interface with an existing wired doorbell system or any of the following:

A standard wired bell push
A lit bell push and transformer
A door or window contact
Any device with N/O or N/C, voltage free contacts
Any device which generates appropriate control signals < 24V (AC or DC)
See typical connections (C1-7)

Important Note: Additional wiring can be brought into the push through the grommet in the back of the push. Once the grommet has been pierced or removed, we recommend that the push is mounted indoors.

Diagram Application Operation

Typical Connection

IMPORTANT

For C7 connection:

Connect converter terminal 3 to the negative (-) terminal of the batteries in the wired chime and con verter terminal 1 to the positive (+) ter minal of the batteries in the wired chime.

For C5 and C6 connections:

Turn off power before connecting converter to transformer.

Mounting the bell push/converter

Mount using either the double- sided adhesive pad or the screws provided (see Fig 3). Test your push before mounting. Avoid mounting on metal structures.

Fig. 3

Specification

Troubleshooting

Troubleshooting Continued

Guarantee

Honeywell guarantees this product for 1 year from the date of purchase. Proof of purchase is required; this does not affect your statutory rights. If you require further information about your product, call the Honeywell helpline at 1-800-468-1502.

Disposal & Recycling

Batteries and waste electrical products should not be disposed of with household waste. Please recycle where these facilities exist. Check with your local authority or retailer for recycling advice.

Declaration

Honeywell hereby declares that this product complies with Part 15 of the FCC rules and Industrial Canada standards. This device operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation.

Caution: Changes or modifications not expressly approved by the party responsible for regulatory compliance could void the users authority to operate the equipment.

Wireless Converter/Extender/Bell Push