PlanetAudio PCAM40B Rear View License Plate Mount Camera User Manual
- June 7, 2024
- PlanetAudio
Table of Contents
Rear View License Plate Mount Camera
USER MANUAL
PCAM40B
REAR VIEW LICENSE PLATE MOUNT CAMERA.
FEATURING HIDDEN MOUNTING BRACKET
DO NOT FULLY RELY ON REVERSE CAME!
WHEN BACKING UP,
ALWAYS KNOW YOUR SURROUNDINGS
BEFORE BACKING UP.
SPECIFICATION
Above parameters can be modified without notification.
INSTALLATION
1. WIRE CONNECTION
Complete all required connections so that all lines are hidden in vehicle.
2. CAMERA INSTALLATION
Camera should be installed in the following configuration:
License Plate Frame Mount – Align camera frame with top-set of screw
holes on license plate or license plate frame. Affix camera using license
plate mount screws. See: (diagram 1)
Attention: The camera switch is controlled by reverse gear shift.
OPTIONAL
To remove the distance guide lines:
- Tum the system OFF before proceeding
- Cut the white loop wire located at the connection points (camera end).
- Insulate the wire, using tape or crimp connectors on both ends
- Reconnecting the wire will display the guide lines again.
To invert the camera image:
- Tum the system OFF before proceeding
- Cut the blue loop wire located at the connection points (camera end)
- Insulate the wire, using tape or crimp connectors on both ends,
- Reconnecting the wire will orient the image back to its original position.
TROUBLESHOOTING GUIDE
The following checklist might help to solve the problems when using this unit.
Please double check to ensure connection and procedure of operation is done
properly before using checklist.
PROBLEM CAUSE/SOLUTION
NO IMAGE
Check that power cable is securely connected.
Check to ensure there is a good connection between
video-in and monitor.
Check that REVERSE GEAR is engaged.
Check to ensure correct monitor setup.
IMAGE BLURRING
Check for water/water stain or dust on camera lens.
Clean camera lens
IMAGE SHAKING
Check to insure camera is mounted and secured tightly.
IMAGE SLANTED
Adjust camera mounting bracket
NOTE: If problems persist – consult nearest service dealer. DO NOT
attempt
to disassemble or modify unit.