Pandora PS-331BT Piezoelectric Siren Instructions

June 7, 2024
Pandora

Pandora Logo

Pandora PS-331BT Piezoelectric Siren

Product

A small-size piezoelectric radio siren is designed to work with the Pandora security systems. All control commands are transmitted from a base unit to the siren via a Bluetooth protocol.

ATTENTION! The siren can work with the system equipped with:
Bluetooth 4.2 and Firmware v2.18 and higher; Bluetooth 5.0 and Firmware v3.05 and higher.

FEATURES

  • Control of Bluetooth connection – the siren monitors the presence of the Bluetooth connection with the base unit when armed. In case of loss of connection, the siren will go into alarm mode for 30 seconds. Setting: Inputs and outputs –> Mode of Bluetooth siren operation (With/without control of BT-connection).

  • External temperature sensor.
    Setting: General settings –> Temperature sensors –> Select engine/interior/exterior temperature sensor (RHM/PS).

  • Input IN RHM/PS with adjustable operation logic.
    Setting: Inputs and outputs –> Settings of RHM, PS input –> Polarity of IN RHM,PS input; Inputs and outputs –> Inputs –> IN RHM/PS (NO/NC).

  • Output CH BLE PS with adjustable operation logic. Setting: Inputs and outputs –> Outputs –> CH BLE PS. Time channel –> Select channel –> CH BLE PS.

PAIRING WITH A SECURITY SYSTEM

Enter the programming level «Pairing an additional device RHM-03BT or PS- 331BT»:

  • Connect the wires «4 (Green) – PROGRAMMING» and «2 (Black) GROUND(-)». Connect them to the ground (-).
  • Connect the wire «1 (Red) – POWER SUPPLY (+12V)» to a constant power supply (+12V).
  • The system will conrm pairing with a sound signal from the Siren/Beeper.
  • Pairing will be finished automatically or it will be required to press the VALET button to finish. It depends on the system model.
  • Exit programming mode;
  • Disconnect the wire «4 (Green) – PROGRAMMING» and insulate all unused wires. Connect the power supply wires to the constant power supply circuits of a vehicle.

WARNING! Do not place the siren near the hot surfaces exceeding the siren’s operating temperature (engine, exhaust system, etc.)

Image 02

WARNING! The siren must be installed in the places that exclude mechanical damage and ingress of corrosive liquids and water. Do not shield the built-in antenna.

SPECIFICATION

  • Sound Pressure, db: 105-118
  • Voltage, V: 12
  • Current Consumption in Active Mode, mA: 300
  • Data Transmission Protocol of 2.4GHz: Bluetooth 4.2 Low Energy
  • IP Code: IP65
  • Operating Temperature, С°: from -40 to +85
  • Dimensions, mm: 88х62,2х18,2

Web-site: pandorainfo.com
Customer support: support@pandorainfo.com

Pandora Logo

References

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals