HOMMIE Bluetooth USB Dongle Adapter User Manual

HOMMIE Bluetooth USB Dongle Adapter User Manual

Bluetooth Adapter Introduction

• Front
  ![Product Overview](https://manuals.plus/wp- content/uploads/2021/08/Screenshot_1-61-300x194.jpg)****

• Side
  ** **

TX: Transmitter | RX: Receiver****

1. Screen: Three-line Display: TX/RX Mode Display;
   Searched Device; Volume Display

2. Left Button ①:
   Press once: previous song/up; Long press: volume –

3. Middle Button ②:
   Long press: switch TX/RX mode;

4. Right Button ③:
   Press once: next song/down; Long press: volume +

5. 3.5mm Audio Interface ④

Use on TV to Pair with Bluetooth Headphone or Bluetooth Speaker

1. Plug the USB end of the adapter into the USB port of TV or USB charger.
2. Connect the 3.5mm audio cable to the audio output interface of the TV.
3. Keep the Bluetooth headphone/speaker in pairing mode within 30cm of the adapter.
4. Check the searched devices on the screen, use the left and right button to select the Bluetooth device to be connected (the device name is displayed in white), and press the middle button to confirm pair (the device name is displayed in green).
5. Left or right button: press to switch to previous or next song, long press to adjust the volume.

Note:

1. TV Settings: Some TVs need to set audio output, but different TVs have subtle differences (Here take Letv TV as an example).
2. Some TVs automatically mute the sound of the TV itself after setting, and some TVs need to press the mute button on the remote control.

**Use on PC to Pair with Bluetooth Headphone or Bluetooth Speaker

**

**

**

1. Plug the Bluetooth adapter into the USB interface 4 of PC. NO need to plug in audio cable.
2. Refer to the step 3.4.5 of “Use on TV” part to connect Bluetooth headphone/speaker.
   Note : After pairing is complete, if the Bluetooth headphone/speaker has no sound, please click Start — Settings — System — Sound and select YET-T1 as the output device on the computer.

**Use on Sono/Speaker/Car to Pair with Smartphone

**

**

**

1. Use the 3.5mm audio cable to connect the adapter and Sono/speaker/car via the 3.5mm interface.
2. Plug the USB end of the adapter into USB port or USB charger for power supply.
3. Long press the middle button to switch the adapter to RX mode.
4. Turn on the Bluetooth of mobile phone, search for 5 “YET-T1”, click and pair.
5. Left or right button: press to switch to previous or next song, long press to adjust the volume.

Trouble Shooting

1. Fail to connect?
   A: Please confirm whether the Bluetooth device is within 30cm of the adapter and is in pairing mode; Unplug the adapter and try again.

2. The soundtrack is not in sync with the picture, there is a delay?
   A: The delay error of the adapter is about 60ms. It is recommended that the Bluetooth device is CSR devices and Apple earphones.

3. There is noise?
   A: The product can only be used with the delivered shielded audio cable to minimize noise interference. Using other audio cables can not guarantee the effect.

4. Can’t transfer files?
   A: You can only connect to audio equipment to play music, and cannot transfer files.

E-mail : hommiehk@hotmail.com

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>