SHELLY Plug S User Guide
- June 7, 2024
- Shelly
Table of Contents
SHELLY PLUG S
USER AND SAFETY GUIDE
Shelly® Plug S by Allterco Robotics is intended to be placed into a standard Plug Type F (IEC) in order to control the electric power through it. Shelly may work as a standalone device or as an accessory to a home automation controller.
Specification
-
Power supply: 110-230V ±10% 50/60Hz AC
-
Max load: 12A / 230V, 50/60Hz
-
Complies with EU standards: RE Directive
2014/53/EU, LVD 2014/35/EU, EMC 2014/30/EU, RoHS2 2011/65/EU -
Working temperature: -20°÷40 °C
-
Radio signal power: 1mW
-
Radio protocol: WiFi 802.11 b/g/n
-
Frequency: 2412-2472 MHz(max. 2483.5 MHz);
-
Operational range: up to 50 m outdoors or up to 30 m indoors
-
Dimensions (HxWxL): 70x44x 44 mm.
-
Electrical consumption: < 1W
-
SAR: 1.15 W/Kg
Technical Information
• Control through WiFi from a mobile phone, PC, automation system or any other
Device supporting HTTP and/or UDP protocol.
• Microprocessor management.
⚠ CAUTION! Danger of electrocution. Connecting the device to the power
grid has to be performed with caution.
⚠ CAUTION! Do not allow children to play with the device, especially with
the Power Button. Keep the devices for remote control of Shelly (mobile
phones, tablets, PCs) away from children.
Introduction to Shelly
Shelly® is a family of innovative Devices, which allow remote control of electric appliances through mobile phones, PC or home automation systems. Shelly® uses WiFi to connect to the devices controlling it. They can be in the same WiFi network or they can use remote access (through the Internet). Shelly® may work standalone, without being managed by a home automation controller, in the local WiFi network, as well as through a cloud service, from everywhere the User has Internet access. Shelly® has an integrated web server, through which the User may adjust, control and monitor the Device. Shelly® has two WiFi modes – access Point (AP) and Client mode (CM). To operate in Client Mode, a WiFi router must be located within the range of the Device. Shelly® devices can communicate directly with other WiFi devices through HTTP protocol. An API can be provided by the Manufacturer.
Shelly® devices may be available for monitor and control even if the User is
outside the range of the local WiFi network, as long as the WiFi router is
connected to the Internet. The cloud function could be used, which is
activated through the web server of the Device or through the settings in the
Shelly Cloud mobile application.
The User can register and access Shelly Cloud, using either Android or iOS
mobile applications, or any internet browser and the website:
https://my.Shelly.cloud/.
Installation Instructions
⚠ CAUTION! Danger of electrocution. Even when the device is turned off, it
is possible to have voltage across its clamps.
⚠ CAUTION! Do not connect the Device to appliances exceeding the given max
load!
⚠ CAUTION! Before beginning the installation please read the accompanying
documentation carefully and completely. Failure to follow recommended
procedures could lead to malfunction, danger to your life or violation of the
law. Allterco Robotics is not responsible for any loss or damage in case of
incorrect installation or operation of this device.
⚠ CAUTION! Use the Device only with a power grid and appliances which
comply with all applicable regulations. A shortcircuit in the power grid or
any appliance connected to the Device may damage it.
⚠ CAUTION! The Device may be connected to and may control electric
circuits and appliances only if they comply with the respective standards and
safety norms.
Factory Reset
You can return your Shelly Plug to its Factory Settings by pressing and
holding the Button for 10 seconds.
Upon successful factory reset Shelly’s WiFi LED will flash Red/Blue.
Declaration of conformity
Hereby, Allterco Robotics EOOD declares that the radio equipment type Shelly
Plug S is in compliance with Directive 2014/53/EU, 2014/35/EU, 2004/108/ WE,
2011/65/UE. The full text of the EU declaration of conformity is available at
the following internet address https://shelly.cloud/knowledge-base/devices
/shelly-plug-s/
Manufacturer: Allterco Robotics EOOD
Address: Bulgaria, Sofia, 1407, 103 Cherni vrah Blvd.
Tel.: +359 2 988 7435
E-mail: support@shelly.cloud
Web: http://www.shelly.cloud
Changes in the contact data are published by the Manufacturer at the official
website of the Device http://www.shelly.cloud
All rights to trademarks She® and Shelly® , and other intellectual rights
associated with this Device belong to Allterco Robotics EOOD.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>