Classic Mosquito Net CLDMT-GR-200X100 Magnetic Screen Door User Guide
- June 7, 2024
- Classic Mosquito Net
Table of Contents
Classic Mosquito Net CLDMT-GR-200X100 Magnetic Screen Door User Guide
Clean the door and make sure its dry
Wait for few seconds until door frame is dry
Measure the center of top door frame & mark with pensil/chalk
Place the screen on the floor.
Cut roll of velcro into equal length with top & 2 side of screen door
Attached the velcro strips to top & each side of screen door without removing white tape
Peel off the white backing paper from top side of screen only
Do not remove backing paper from side at this step.
Hold the center of screen door to the center of the door frame & make sure there is no room under the bottom screen but high enough not to drag on the ground. And then stick screen, starting from top center, slightly higher than top side and working outward.
Check & make sure the screen open & closes without gaps.
Make adjustments if necessary.
For an extra support , you can use the provided nails on wooden door frame.
Notes –
The Central part of the screen door should be slightly higher than the two
side in order to be balanced. Pres the adhesive tape until secure & don’t move
the curtain for at least 24 hours. Since the product is made from polyester
fiber and could have characteristic, smell, please allow mesh to air-dry
before use.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>