BLACK STONE WRCS1-4 Wireless Remote Control User Manual
- June 7, 2024
- BLACK STONE
Table of Contents
Blackstone Indoor Remote Controlled Outlets
Set of 4 Indoor Remote Outlets
Wireless Remote Control
WRCS1-4
Outdoor Power Stake and Remote Package Includes:
(4) Wireless Wall Outlet Receivers (Receiver Units)
(1) Four Button Hand Held Remote Control (Sender Unit)
(1) Battery Type: DL2032
Features:
Blackstone Indoor Remote Controlled Outlets operate on a radio frequency and are not dependent on line of sight. They will perform regardless of walls, doors, and floors.
Operation:
Remove Pull Tab from Battery Chamber
In order for the remote to function, you need to remove the protective insert
from the handheld remote control to allow the battery to make proper contact
with the handheld remote control.
Plug-in Receiver Units
Plug the individual wall receiver units into any standard grounded indoor
125V/60Hz wall outlet. Please Note: The Indoor Remote Controlled Outlets
require a grounded outlet. If you do not have an indoor grounded outlet,
contact your electrician to upgrade your electrical system for your safety.
Operation and Safety
Use only 1 Indoor Remote Controlled Outlet per AC outlet. A distance of at
least 24 inches should be maintained between individual receiver units. Do not
overload an individual Indoor Remote Controlled Outlet beyond 1875 Watts.
Reasonable care should be taken to ensure the Receiver Unit is
correctly inserted into the wall outlet. For indoor use only.
This product is not intended to be used outside of the limits noted above. For
residential use only. Any use in such a manner or in any manner contained
herein shall void any warranty conveyed with this product and can cause
serious damage to person and/or property. Should use occur outside of the
manner prescribed in these instructions Blackstone International, Ltd. shall
not be liable for such improper use.
Receiver Function:
The power button is located on the front of the receiver. The power button
can be used to manually switch the receiver on and or off independently of the
included handheld remote control. A blue LED light will appear around the
power button when the receiver is plugged in. If no lights appear in the clear
ring around the power button, check to make sure that the power for your wall
outlet is turned on.
Remote Function:
The remote controls each receiver included in this package. The red LED light
on the front of the remote indicates when the remote is in use. Each button
corresponds to a specific receiver. Example: remote button 1 controls receiver
- Pressing the remote button for the corresponding receiver will cause the
receiver to turn on and or off.
Remote Battery Replacement:
If the operation of the receiver units becomes erratic, it may be necessary to replace the battery in the hand-held remote unit. To do this, first, remove the battery compartment cover. Press the tray release button on the back of the remote (refer to figure below). Next, remove the depleted battery and discard it according to local ordinances. Be sure the correctly install the new battery. Replace battery compartment cover and test by using it to control the Indoor Remote Outlets. Important: Install only new batteries of the same type in your product. Failure to insert batteries in the correct polarity, as indicated in the battery compartment, may shorten the life of the batteries or cause batteries to leak. Do not mix old and new batteries. Do not mix Alkaline, Standard (Carbon-Zinc) or Rechargeable (Nickel Cadmium), or (Nickel Metal Hydride) batteries. The danger of explosion if the battery is incorrectly replaced.
Batteries should be recycled or disposed of as per state and local guidelines.
WARNING: This product contains a button battery. If swallowed, it could cause severe injury or death in just two hours. Seek medical attention immediately.
1 Year Limited Warranty:
This product is warranted to the original purchaser only for a period of 1
year from the date of purchase for products damaged due to defect in
workmanship and materials. Proof of purchase is required to obtain warranty
service. The warranty is for replacement only. No service parts are available
for these products. No other warranties are expressed or implied. Batteries
are not covered under this warranty.
For warranty service, please contact Blackstone International Customer Service
by phone: 1-888-525-7969 or email:
customerservice@blackstoneltd.com.
A product may be submitted for warranty replacement by mailing the complete
product along with proof of purchase to:
Blackstone International, Ltd.
2018 Lord Baltimore Drive Baltimore, MD 21244
This warranty gives you specific legal rights, and you may also have other
rights which vary from state to state.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>