hama Radio-Controlled Power Socket Instructions

June 6, 2024
Hama

hama logo

hama Radio-Controlled Power Socket

Thank you for choosing a Hama product.
Take your time and read the following instructions and information completely. Please keep these instructions in a safe place for future reference. If you sell the device, please pass these operating instructions on to the new owner.

Explanation of Warning Symbols and Notes

Risk of electric shock
This symbol indicates product parts energized with a dangerous voltage of sufficient magnitude to constitute a risk of electric shock.

Warning: This symbol is used to indicate safety instructions or to draw your attention to specific hazards and risks.

Note: This symbol is used to indicate additional information or important notes.

Package Contents

  • 433 MHz radio-controlled socket
  • These operating instructions

Safety Notes

  • Do not cover when in use.
  • There is voltage running through the socket unless it is unplugged.
  • Only switch on and use with the safety covers closed.
  • Do not use any heat-generating devices (such as electric blankets, coffee machines, etc.) with this product. There is a risk of fire and injury.
  • Do not use this product with any devices that are motorised or any devices that have a rotating component or workpiece. There is a risk of injury.
  • Never connect multiple units of this product in series.
  • The product is intended for private, non-commercial use only.
  • Use the product for its intended purpose only.
  • Protect the product from dirt, moisture and overheating, and only use it in a dry environment.
  • The product is intended for indoor use only.
  • Do not use the product in the immediate vicinity of heaters or other heat sources or in direct sunlight.
  • Use the item only in moderate climatic conditions.
  • Keep this product, as all electrical products, out of the reach of children!
  • Do not use the product in areas where the use of electronic devices is not permitted.
  • Do not use the product in moist environments and avoid splashes.
  • Do not drop the product and do not expose it to any major shocks.
  • Do not modify the product in any way. Doing so voids the warranty.
  • Keep the packaging material out of the reach of children due to the risk of suffocation.
  • Dispose of packaging material immediately according to locally applicable regulations.
  • Lay all cables so that they do not pose a tripping hazard.
  • Do not bend or crush the cable.
  • Always pull directly on the plug when disconnecting the cable, never on the cable itself.
  • Do not operate the product outside the power limits given in the specifications.
  • Never connect the radio-controlled socket to an extension cable or adapter. It must be plugged directly into a mains socket. Connecting the timer in any other way may cause it to overheat.
  • Use the timer switch only in permanent wall sockets.

Connecting and getting started

Risk of electric shock

  • Do not open the device or continue to operate it if it becomes damaged.
  • Do not use the product if the AC adapter, the adapter cable or the mains cable are damaged.
  • Do not attempt to service or repair the product yourself. Leave any and all service work to qualified experts.

Warning

  • Only operate the product from a socket that has been approved for the device. The socket must be installed close to the product and must be easily accessible.
  • Disconnect the product from the power supply using the On/ Off switch – if this is not available, unplug the power cord from the socket.
  • If using a multi-socket power strip, make sure that the total power consumption of all connected devices does not exceed the power strip’s maximum throughput rating.
  • If you will not be using the product for a prolonged period, disconnect it from mains power.

Now plug the radio-controlled socket into an earthed socket.
To test the radio-controlled socket and for manual use without a remote control, press the “On/Off” button. When the button is pressed, the LED of the radio-controlled socket should light up.
When you press the button again, the LED should go out.
This product is for indoor use only.

Note: On extending Hama radio-controlled socket sets. It cannot be guaranteed that radio remote controls of other manufacturers will work.

Learn function of the radio-controlled socket

Press and hold the “LEARN” button for approx. 3 seconds until the LED starts to flash. Then select the desired channel by pressing the corresponding “ON” button.
The LED on the radio-controlled will stop blinking when it has successfully learnt the frequency.
If the learning is unsuccessful, the remote control socket will leave learn mode after 15 seconds. In this case, repeat the process. It is also possible to assign a channel multiple times (multiple radio controlled sockets can respond to the same remote control button).
If you wish to delete a programmed channel, first press the “LEARN” button until the LED flashes. Press the “OFF” button for the channel to remove its programming.

Troubleshooting

Remote control does not work
Check whether the battery has been inserted with the poles facing the proper directions. You can check this by making sure that the label on the battery corresponds to the polarity marked inside the battery compartment.
If the control LED on the remote control does not light up when you press a button, even when the battery has been inserted correctly, then it is possible that the remote control has a technical defect.
If this is the case, please contact our customer service team or the retailer where you purchased this product.

The radio-controlled socket cannot be switched on or off even though the remote control is working properly
Repeat the steps above under “Learn function of the radio controlled socket” and, if necessary, contact Hama technical support or the retailer where you purchased this product.

Care and Maintenance

Only clean this product with a slightly damp, lint-free cloth and do not use aggressive cleaning agents.

Note: Disconnect the device from the power supply before cleaning or if it will not be used for a long period of time.

Warranty Disclaimer

Hama GmbH & Co KG assumes no liability and provides no warranty for damage resulting from improper installation/mounting, improper use of the product or from failure to observe the operating instructions and/or safety notes.

Technical Data

Input voltage 230 V~/50 Hz/16 A
Output voltage 230 V~/50 Hz/16 A
16 (2) A, 3680 W;
Maximum connection i.e. up to 16 A for resistive
power loads and up to 2A for
inductive loads
Signal frequency 433.92 MHz
Transmitter duty cycle < 10%
Receivers category Class 3

Recycling Information

Note on environmental protection:
After the implementation of the European Directive 2012/19/EU and 2006/66/EU in the national legal system, the following applies: Electric and electronic devices as well as batteries must not be disposed of with household waste. Consumers are obliged by law to return electrical and electronic devices as well as batteries at the end of their service lives to the public collecting points set up for this purpose or point of sale. Details to this are defined by the national law of the respective country. This symbol on the product, the instruction manual or the package indicates that a product is subject to these regulations. By recycling, reusing the materials or other forms of utilising old devices/Batteries, you are making an important contribution to protecting our environment.

Declaration of Conformity
Hereby, Hama GmbH & Co KG declares that the radio equipment type [00121955] is in compliance with Directive 2014/53/EU. The full text of the EU declaration of conformity is available at the following internet address:
www.hama.com -> 00121955 -> Downloads.

Service & Support
www.hama.com
+49 9091 502-0

All listed brands are trademarks of the corresponding companies. Errors and omissions excepted, and subject to technical changes. Our general terms of delivery and payment are applied.

hama logo

References

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals