TRAXXAS KC2993-R02 Sledge Sway Bar Kit Instruction Manual
- June 3, 2024
- Traxxas
Table of Contents
TRAXXAS KC2993-R02 Sledge Sway Bar Kit Instruction
Front and Rear Sway Bar Installation Instructions
Kit contents
- Sway bars
- Red color band, 3.0mm (stiff)
- Green color band, 2.8mm (stiff)
- Yellow color band, 2.6mm (intermediate)
- Black color band, 2.4mm (intermediate)
- Blue color band, 2.2mm (soft)
- White color band, 2.0mm (soft)
- Front linkage* (2)
- Rear linkage* (2)
- Sway bar mounts (2)
- Collars (2)
- 2.5x10mm BCS (8)
- 3x4mm GS (with threadlock) (6)
- 3x4mm GS (4)
- 3×18 mm CS (2) Note: Front only. Reuse the factory-installed 3×25 mm CCS used in the rear arm mudguards
Tools required:
- 1.5mm hex wrench
- 2.0mm hex wrench
- 2.5mm hex wrench
The RF (right front)/LR (left rear) or LF (left front)/RR (right rear) molded on the link indicates that this link is to be installed only in those locations on the vehicle.
| Front Sway Bar | Rear Sway Bar | |
|---|---|---|
| Reduce Understeer | Soften | Stiffen |
| Reduce Oversteer | Stiffen | Soften |
| Smoother / High Grip | Stiffen | Stiffen |
| Rougher / Lower Grip | Soften | Soften |
| Severe Terrain | Remove | Remove |
If you have questions or need technical assistance, call Traxxas at 1-888-TRAXXAS (1-888-872-9927) (U.S. residents only)
SWAY BAR INSTALLATION
Front installation is shown. The rear installation is similar.
- Note: Thread the 3x4mm GS into the holes until they touch the bar, and then back off slightly. The sway bar must pivot freely in this mount.
- Important: The 3x4mm GS must be tightened completely to secure the sway bar to the vehicle.
TRAXXAS.com
Traxxas, 6250 Traxxas Way, McKinney, TX 75070,
- Phone: 972-549-3000,
- Fax: 972-549-3011,
- e-mail: support@Traxxas.com
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>