TRAXXAS 3794 LED Lighted Bumper Kit Installation Guide
- June 4, 2024
- Traxxas
Table of Contents
TRAXXAS 3794 LED Lighted Bumper Kit
Kit contents
- Front bumper assembly
- Rear bumper assembly
- Power Y-harness
- 3x12mm button-head cap screw (BCS) (1)
- 3x30mm button-head cap screw (BCS) (1)
- 3x40mm button-head cap screw (BCS) (1)
- 4x12mm countersunk cap screw (CCS) (4)
- Zip ties (3)
Tools required
- 2mm hex wrench
- 2.5mm hex wrench
- Phillips screwdriver
- Silicone grease
POWER WIRE HARNESS INSTALLATION
- A1. Remove the wire clamp by removing the two 2.5x8mm CS (Fig 1).
- A2. Remove the receiver box cover by removing the two 3x10mm CS (Fig 1).
- A3. Route the power Y-harness into the receiver box and plug it into any open channel on the receiver. Position the power Y-harness in a wire guide of the receiver box.
- A4. Apply a small bead of silicone grease (part #1647, sold separately) to the wire clamp foam. Install the wire clamp and tighten the two 2.5x8mm cap screws securely. Note: Make sure not to pinch the wires in the clamp.
- A5. Make sure the blue O-ring seal (Fig 1) is properly seated in the groove in the receiver box so that the cover will not pinch it or damage it in any way.
- A6. Reinstall the cover on the receiver box and tighten the two 3x10mm cap screws securely. Inspect the cover to make sure that the O-ring seal is not visible.
FRONT BUMPER AND HEADLIGHTS INSTALLATION
Model 37054 shown. Your components and hardware may differ.
- B1. Remove the existing front bumper from the chassis by removing the 4x12mm CCS (2).
- B2. Install the new front bumper on the chassis with the four included 4x12mm CCS.
- B3. Route the wire harness from the front bumper along the chassis toward the receiver box. Plug the red male connector from the power Y-harness into the red female connector from the headlights harness.
- B4. Use the included zip tie (1) to secure the harness to the chassis (refer to Fig. 2 Chassis Wiring for more detail).
REAR BUMPER GUARD AND TAIL LIGHTS INSTALLATION
Model 37054 shown. Your components and hardware may differ.
- C1. Remove the 3×30 BCS (1) and 3×23 BCS (1) from the gearbox housing as shown.
- C2. Attach the rear bumper guard to the gearbox housing with the included 3x30mm BCS (1) and 3x40mm BCS (1).
- C3. Attach the rear bumper guard to the gearbox housing on the opposite side with the included 3x12mm BCS (1).
- C4. Route the wire harness from the rear bumper guard along the chassis toward the receiver box. Plug the red male connector from the power Y-harness into the red female connector from the tail lights harness.
- C5. Use the included zip tie (1) to secure the harness to the chassis (refer to Fig. 2 Chassis Wiring for more detail).
Traxxas, 6250 Traxxas Way, McKinney, TX 75070, Phone: 972-549-3000, Fax: 972-549-3011, e-mail: support@Traxxas.com
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>