wick KCM-140 Candle Maker Machine Instruction Manual

Table of Contents

$wick KCM-140 Candle Maker Machine - $2$$

$wick KCM-140 Candle Maker Machine - $1$$

Instruction Manual

CAUTION —The WICK reaches high temperatures. Do not touch metal parts when in use as they may cause burns.
This is not a toy and is not intended for use by children. Keep out of reach of children.
Never leave the WICK unattended while in use.
Do not pour liquid wax down the drain. It will cause blockage.
Do not immerse the WICK in water or other liquid. The danger of electric shock.
Misuse may cause burns, electric shock, and other injuries.
Always use the WICK on an uncluttered, heatproof, and level work surface.
After using the WICK let it cool naturally before storing.
There are no customer serviceable parts inside the unit. Do not disassemble the WICK.
If the supply cord is damaged, it must be replaced by the manufacturer, its service agent, or similarly qualified persons in order to avoid a hazard.
For domestic use only. Use only for the intended purposes.
A small emission of smoke from the WICK upon first use is normal.

GETTING STARTED

Select a heat-resistant and level work surface.
Use cardboard or newspaper to protect your work surface from dripped wax as hardened wax is sometimes difficult to remove.
Before getting started, ALWAYS check:
• the Temperature Control Knob is at the “0”, OFF position.
• the Wax Dripping Valve is at the “CLOSED” position.
NOTE: No indicator light should light up when the knob and valve are both closed.
During operation:
• The RED indicator light indicates the heater is ON.
• The BLUE indicator light indicates the valve is OPEN (the wax will drip!).

PREPARING THE CANDLE MOLD

Choose the desired candle mold size.
Check that the mold is clean and completely dry.
NOTE: Do not use abrasive cleaners to clean the plastic candle molds. They will leave scratches. If needed, use a hairdryer to warm residual wax and then wipe with a dry cloth.
Check that the bottom part of the plastic candle mold is screwed on properly to avoid leaking. NOTE: Do not screw mold too tightly or it will be difficult to remove once the wax has set.
Cut a piece of wick (approx. 7-8 inches) and put the wick through the bottom hole of the plastic candle mold.
At the bottom of the candle mold, press the small rubber stopper into the hole while leaving approx. 2 inches of wick outside. This rubber stopper prevents the leaking of melted wax during the forming process.

WICK	ACCESSORIES
Model: KCM-140	1Ib Paraffin Wax
Power: 140W	∼72″ Cotton Wick
Voltage: 120V 60Hz for US	3 Metal Rods
Volume maximum: 230 mL	3 Candle Rubber Stoppers
Max Temperature: fv110 C	4 Wax Pigment Packs (Red, Yellow, Blue, White)