Air Cooler IIGLOACT001 Instruction Manual

**Air Cooler IIGLOACT001 Instruction Manual

**

Safety Warnings and Precautions

In order to use the product more conveniently and avoid any danger caused by wrong operation, please pay close attention to the warnings and instructions in this manual.

1. This appliance can only be used by children aged from 8 years and above. And persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning use of the appliance in a safe way and understand the hazards Children shall not play with the appliance. Cleaning and user maintenance shall not be made by children without supervision.
2. Children of less than 3 years should be kept away unless continuously
3. Children aged from 3 years and less than 8 years shall only switch on/off the appliance provided that it has been placed or installed in its intended normal operating position and they have been given supervision or instruction concerning use of the appliance in a safe way and understand the hazards Children aged from 3 years and less than 8 years shall not plug in, regulate and clean the appliance or perform user maintenance.
4. CAUTION — Some parts of this product can become very hot and cause Particular attention has to be given where children and vulnerable people are present.
5. If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly qualified persons in order to avoid a
6. WARNING: In order to avoid overheating, do not cover the
7. The heater must not be located immediately below a socket
8. Do not use this heater in the immediate surroundings of a bath, a shower or a swimming
9. WARNING: This heater is not equipped with a device to control the room Do not use this heater in small rooms when they are occupied by persons not capable of leaving the room on their own, unless constant supervision is provided.
10. This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their
11. Children should be supervised to ensure that they do not play with the appliance.

• If the product has any failure, please send it to the repair station or notify the service center; do not disassemble or replace the

• Disassembly or modification without permission will affect the safety of the product

• Do not touch the power cord plug with wet hands

• Risk of electric shock.
  

• Never insert wooden sticks, metal sticks and other objects into the inlet and the outlet.

• It may cause leakage, short circuit and damage to the product.

• Do not spray insecticides and flammable sprays around the product

• It may cause damage to the product.
  

• Avoid placing the product at the outlet for long time or blow to the children

• It may cause illness or affect the health of young children.
  

• Do not pull the cord when removing the power plug.

• It may cause power cord damage, electric leakage and other hazards
  

• Make sure that the power plug doesn’t stick foreign body, and!  U” insert the plug.

• It will lead to the risk of electric leakage.
  

• Exception handling

• When the product has unpleasant smell or abnormal noise in use, immediately stop using and unplug the power.
  

• The water level of the tank shouldn’t exceed the maximum level, and shouldn’t be lower than the minimum level when the cooling/humidification function is turned

• After water is filled, do not tilt or collide while placing or moving, to prevent water splashing
  

• If the product has been dumped and there is water inside, immediately pull out the plug and wait for 24 hours before starting.

• Do not bend the power cord or place heavy objects on it
  

• It Will lead to the risk of electric leakage
  

Features

1. Oscillating function: 80° horizontal auto saying;
2. Timing function: IH, 2H, 4H, 8H;
3. Humidification, cooling and heating function;
4. Cooling-heating conversion (cooling power is up to SOW, heating power is 1200W- 2000W);
5. Three speed levels: High, medium and low;
6. Room temperature setting: 22°C and 28°C;
7. Wet curtain, large evaporation, good cooling effect;
8. Water shortage protection;
9. Remote control function;
10. Dumping power protection function; Indicator color: Blue (standard)
11. Power, shutdown, button sound reminder (power on: Bi Bi, button pressing: Bi, power off: Bi-);

Features and names of Product Components

1. Handle
2. Operation panel and function display window
3. Remote receiver window
4. Air outlet
5. Front shell
6. Water tank
7. Remote control storage
8. Carbon ignition switch
9. Rear shell
10. Back cover
11. Water injection gate
12. Water outlet pipe
13. Base
14. Power cord

Accessories

• Ice Pot: 2

• Remote Control: 1

• Display panel and poperation panel.
  
  The buttons from left to right are:
  “Room temperature setup” button, “Wind speed” button, “Heater” button, “Cooler/ Humidifier” button, “Timer” button, “Swing” button, and “On/Off” button.

Product Installation and Usage

Use of function buttons

The buttons are touch type. You can touch the buttons on the operation panel to trigger the corresponding functions.

1. When the power is turned on for the first time, the buzzer makes Bi Bi tone, the power indicator turns on and enters standby state; all buttons except ON/OFF are

2. ON/OFF button: Press this button in the standby mode to enter the default working state (run 3 seconds at medium speed and then switch to low speed; the low level indicator is on), and the power indicator turns

3. Swing button: Swing function is disabled when the unit is turned on; in power on state, press this button to turn on/off the swing function; when the swing function is turned on, the SWING indicator turns on, and when the swing function is turned off, the SWING indicator turns off

4. Timer button: In power on state: press the Timer button to set the timer among 1h, 2h, 4h, 8h, Off, 8h, Timer off, 1h
   After setting the timer, the unit immediately enters countdown state, the timer LED indicates the remaining value of countdown (for example: if the timer is set to 8H and it has gone to 4H, the unit shows the 4H indicator; it still displays 8H when the timer is 8-4), the unit turns off and enters standby state after countdown, and no Bi tone is made.

5. Humidifier button: In power on state, press this button to switch on/off the

   • In power on state, press this button to switch on/off the The initial state is off.
   • The humidifier LED turns on/off with the
   • Water shortage protection switch is integrated: When the humidifier function is turned on and the water pump has worked for SOS, the system will turn off the pump if water level switch off (no water) is detected for 500mS continuously; the buzzer makes Bl-bi sound and alarms 5S, the humidifier function turns off and reminds the user to add The Heater button is valid when the humidifier function is turned on; on the other hand, the Humidifier button is also valid when the heater function is turned on.

6. Heater button: In power on state, press this button to turn on the heater at low level when the heating assembly is in place, and the wind speed is medium and can’t be adjusted; press this button again to switch the heater to high level, and the wind speed is medium and can’t be adjusted; switch the heater to low level, and the wind speed is medium and can’t be adjusted; it switches among low level, high level, low level, high in turn. Press the Mode button or Speed button to turn off this function. The heating assembly moves to air outlet and stops 10S, and then returns to the initial position. (Note: The fan has 10S delay when the unit is turned off in heater state, and no delay in cooler state)

7. Speed button: In power on state, press this button to switch the speed among low level, medium level, high in turn, and the corresponding indicator turnson; mode state / heater function can’t be turned on at the same time

8. Room temperature setup button: In power on state, press the temperature button to adjust the set temperature among 22°C, 28°C, no, 22°C in turn. When the room temperature reaches the set temperature, PTC stops working, and the cooler starts running; when the room temperature is 2°C lower than the set temperature, PTC automatically starts to work.

Filling water

If the cooler and humidifier functions are needed, please add water to the tank: first remove the water injection gate in the rear side of the unit, and then slowly fill water into the tank (Fig. 1 & 2); please note that:

1. Pay attention to the water level display on the front of the air conditioning fan when adding water (Fig. 3).
2. Do not exceed the maximum water level when adding water (Fig. 3).
3. Insert the water injection gate in place after filling the
4. Be sure to use clean tap
5. Tip: It is normal if the unit is accompanied by a slight smell or the water in the tank has slight discoloration when it is used for the first time. It is non-toxic and harmless and will not affect your health.

Use of ice pot:

Ice pot has unique cold and heat preservation characteristics. It can slowly absorb the heat in the water to keep the temperature of water in the tank always lower than the ambient temperature for several hours, so that the wind being blown from the air conditioning fan is cooler.

1. Put the ice pot into the freezer until the ice box is completely
2. Put a frozen ice box into the water tank of the air conditioning fan from the water injection gate, put back the gate, and the water temperature in the tank will be lower than the ambient temperature about ten minutes
3. The unit is equipped with two ice boxes for exchange.
4. It is strictly prohibited to open the ice box or swallow the ice.
   

Use of remote control:

1. First open the battery compartment in the back of the remote control, and then install a 3V CR2032
2. Please point to the receiver position during
3. Replace the battery (CR2032 3V) when it is Pay attention to the polarity when replacing the battery.

Cleaning and Maintenance

Be sure to turn off the power switch and unplug the power cord before cleaning and maintenance

Outer filter and wet curtain assembly cleaning
If too many foreign matters are attached to the filter, it will affect the air effect, so it should be cleaned at least once every month.

1. Take out the filter and wet curtain assembly in sequence (as shown below).
2. Clean the outer filter with cleanser and soft
3. Soak wet curtain assembly in cleanser for a few minutes, clean and dry.
   

Water tank cleaning

1. Unplug the power and remove the water injection
2. Dip a little cleanser with a towel and wipe the scale inside the tank, then wash with clean water and drain the sewage from the outlet.

Unit surface cleaning

1. Wipe the unit surface with a wet cloth; it is strictly prohibited to rinse with water
2. Do not use corrosive detergent or
3. Before cleaning the unit, be sure to turn off the power switch and unplug the power cord, or there may be electric shock.

Installation after cleaning

1. Install the filter, wet curtain, and water tank properly in
2. Connect to the power and confirm that the product works
3. If the working isn’t normal, please confirm whether the tank is installed in place.

Maintenance

1. If the product won’t be used for a long time, unplug the power plug, package the product and prevent dust from entring
2. Before packaging, ensure that the wet curtain and filter are dry, and there is no water within the tank
3. After packaging, place it in a dry and ventilated place

Technical Parameters

Product   model: IIGL0ACT001
Rated voltage: 220—240 V-
Rated frequency: 50 Hz
Rated power: Heater: 2000W; cooler: SOW
Noise: 55dB
Wind speed: 5m/s
Noise: 55dB
Wind speed: 5m/s
Dimensions (LxWxH): 274mmx274mmx850mm
Information on ERP report is to be added (for the European region).

Environmental Protection

This marking indicates that this product should not be disposed with other household wastes throughout the EU. To prevent possible harm to the environment or human health from uncontrolled waste disposal, recycle it responsibly to promote the sustainable reuse of material resources. To return your used device, please use the return and collection systems or contact the retailer where the product was purchased. They can take this product for environmental safe recycling.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>