iiglo IITER003 Infrared Heater Instruction Manual

iiglo IITER003 Infrared Heater

Patio Heater
(This heater for outdoor use only)
Model: IITER003
Thank you for purchasing your new heater.
These operating instructions will help you use it properly and safely.
We recommend that you spend some time reading this instruction manual in order that you fully understand all the operational features it offers.
Read all the safety instructions carefully before use and keep this instruction manual for future reference.

Safety Warnings

Please follow all the safety precautions listed below for safety and to reduce the risk of injury or electrical shock.

• Read this Instruction Manual carefully to maximise this appliance’s performance and keep for future reference.

• Always ensure that your power supply voltage matches this appliance’s rating label.

• Never leave the appliance unattended while in operation. Always unplug the appliance when not in use.

• This heater is hot when in use. To avoid burns, do not let bare skin touch hot surfaces.

• Caution: Some parts of this product can become very hot and cause burns.
  Particular attention has to be given when children and vulnerable people are present.

• Always use the handle when moving the heater (if available) or hold on the sides if not available (make sure the unit is turned off). Keep combustible materials such as furniture, pillows, bedding, papers, clothes and curtains at least 1m from the heater.

• For safe use of the product, the product installation position should have a minimum height of 1.8 m from the ground, and a minimum distance of 0.5 m from ceiling, roof and both sides walls.

• The heater must not face with the heating element pointing upwards towards a ceiling. The heater element must be facing the area it is to heat.

• Warning: In order to avoid overheating do not cover the heater.

• This appliance can be used by children aged from 8 years and above and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning use of the appliance in a safe way and understand the hazards involved.

• Children shall not play with the appliance. Cleaning and user maintenance shall not be made by children without supervision.

• Do not use the product if there are any visible signs of damage to the appliance.

• Do not attempt to repair or adjust any electrical or mechanical functions on this unit. The unit does not contain any user serviceable parts. Only a qualified electrician should perform servicing or repairs. Attempting to repair the unit yourself will void your warranty.

• If the mains cable is damaged it must be replaced by the manufacturer, its service agent, or similarly qualified persons in order to avoid a hazard.

• Do not handle the element with bare hands. If it is inadvertently touched, remove finger marks with a soft cloth and methylated spirits or alcohol, otherwise the marks will burn into the element causing premature heater failure.

• Do not replace or attempt to replace the element in this product.

• This product is suitable for outdoor use only. Do not operate the appliance in direct sunlight, near heat sources, humid environments or in places near water or other liquids such as bathrooms, shower or swimming pool.

• This product must not be left outdoors exposed to the elements for long periods of time.

• Do not operate with wet hands or spill water or other liquids on to the appliance the mains cable or plug.

• Do not run the power cable under carpeting. Do not cover the power cable with rugs, runner, or similar coverings. Arrange the power cable away from foot traffic and where it will not be tripped over.

• Do not wind the power cable around the unit.

• Do not insert or allow foreign objects to enter any ventilation or opening on the heater, as this may result in electric shock, fire, or damage to the heater.

• To prevent a possible fire, do not block the air vents.

• Do not use the appliance in areas where petrol, paints or other flammable substances are used or stored.

• Always position the appliance with the mains plug in an accessible position and avoid the use of an extension cables as they may overheat and create a potential fire risk.

• Always ensure the heater is plugged into a suitable socket, one that is tested for outdoor use.

• To disconnect heater, turn controls to OFF, then remove plug from socket. Do not unplug by pulling on the power cable.

• Always unplug the unit and ensure the unit is completely cold before moving, cleaning or storing.

• This heater is intended for domestic use only and should not be used commercially for contract purposes. Any alternative use, not recommended by the manufacturer, may result in fire, electric shock, or injury to persons.

• The use of attachments on the heater is not recommended.

• Warning: This heater does not equipped with a device to control the room temperature. Do not use this heater in small rooms when occupied by persons not capable of leaving a room on their own, unless constant supervision is provided.

• Check exterior walls for areas of damage before installing the heater.

• Check exterior walls for communication and electrical cables and pipelines.

• Should any service lines be present in the immediate vicinity do not install your heater, find an alternative location to install this product.

• Do not use this heater with a programmer, timer, separate remote-control system or any other device that switches the heater on automatically, since a fire risk exists if the heater is covered or positioned incorrectly.

• The heater must not be located immediately below a socket-outlet.

• Children of less than 3 years should be kept away unless continuously supervised.

• Children aged from 3 years and less than 8 years shall only switch on/off the appliance provided that it has been placed or installed in its intended normal operating position and they have been given supervision or instruction concerning use of the appliance in a safe way and understand the hazards involved. Children aged from 3 years and less than 8 years shall not plug in, regulate and clean the appliance or perform user maintenance.

Installation on the Wall

Attention! The appliance must be installed on the solid surfaces like concrete and metal. Never install on flammable surfaces!

1. Drill four 8mm diameter holes on the wall and insert four Φ8 plastic anchors. Fix the two L shaped legs on the wall using the M4x35 screws.
   

2. Use four M5X10 screw to install bracket to the product.

3. Fix the product to the L shaped legs on the wall.
   
   You can adjust the product angle.
   Installation positions: Attention! Fixing only at ±5°horizontally is of great importance for permanent operation.
   5°or more slop
   

Safety Distances

Minimum distances required for safety from wall or corners.

Using steps

Step 1: Connect the heater to power

Step 2: Press rocker switch to”-” position
Press Open/Close once, the digital screen shows PO which means power on.

Step 3: Press Open/Close twice, the digital screen shows P1 which means first power setting.

Step 4: Press Open/Close three times, the digital screen shows P2 which means second power setting.

Step 5: After the function is on, 1-24 hours timing shutdown can be adjusted.
The digital screen showing 01 indicates timing one hour, 02 indicates timing two hours, etc.

Operation of Remote Control

1. Stand by or Off
   Switches off the heater or stand by.

2. First setting
   After turn on the heater, you can choose low heating.

3. Second setting
   After turn on the heater, you can choose high heating.

4. Timer
   After the function is on, 1-24 hours timing shutdown can be adjusted.
   The digital screen showing 0 1 indicates timing one hour, 0 2 indicates timing two hours, etc.
   

Maintenance

Attention! Careful and regular maintenance of Infrared Heater is required to attain a long and efficient operation of your appliance.

1. Check the cleanliness of the Reflector and IR-Filament at least once a month. If necessary, apply cleaning and maintenance instructions.
2. The number of checks may be increased considering the amount of the dust in the environment.
3. Check the deformation of the Reflector, Wire and Frame visually while cleaning the appliance. In case of any deformation, consult a qualified technician.
4. Check the power cable and plug visually while cleaning the appliance. In case of any deformation, consult a qualified technician.
5. It is recommended to change the reflector every 2 years for more efficient operation.

Cleaning

Attention! Regular and careful cleaning helps your heater operate for longer years and more efficiently.

1. Unplug your power cable for your safety before cleaning your appliance.
2. Take out the front grid wire through the inlets on the frame using a slotted screwdriver.
3. Make sure that the power is off for your safety. Power cable plug must be unplugged.
4. The reflector and filament must be cleaned with a soft cloth, a smooth brush or cool or dry air. The cloth may be damp but never too wet and the cleaner should not include any chemical.
5. Refrain from using cleaning material likely to damage the reflector (cleanser etc.).
6. Insert the wire grid using a slotted screwdriver.

Specifications

The symbol on the product or in the instructions means that your electrical and electronic equipment should be disposed at the end of its life separately from your household waste.
There are separate collection systems for recycling in the EU.
For more information, please contact the local authority or your retailer where you purchased the product.

Imported by iiglo, østre Kuller0d 4, N-3241 Sandefjord, Norway
www.iiglo.com | Made in China

Read User Manual Online (PDF format)

Download This Manual (PDF format)

Download this manual  >>