amotoys AXE Throw Challenge Instruction Manual

June 6, 2024
amotoys

amotoys AXE Throw Challenge - logo AXE THROW CHALLENGE
Instruction manual

amotoys AXE Throw Challenge

  1. Axe Throw Challenge™ x 1
  2. Self-Sticking Inflatable Axes x 2
  3. Repair Patch x 1

IMPORTANT SAFETY INSTRUCTIONS.

Important safety instructions.
Please read these instructions thoroughly before set up and use.
Keep these instructions in a safe place For future reference.
For ages 5+ Adult setup is required.

Safety Information

WARNING!
To avoid the risk of serious injury or death:

  • Adult supervision is required.

  • Adult assembly required.

  • Setup should be done a safe distance away from fences, garages, houses,
    overhanging branches, laundry lines or overhanging electrical wires.

  • Do not hang on, stand on or tackle this product.

  • Do not use a high-pressure air pump to inflate.

  • Do not use an electric air pump if water or moisture is present. This may result in electric shock.

  • This product is intended to be used as a toy and not as a personal flotation device.

  • Do not use water.

  • Use product only on a grassy, level surface, clear of any obstructions, hard objects or debris. Failure to do so may result in cuts, bruises, or other injuries.

  • DO NOT ALLOW ANYONE TO USE THIS PRODUCT WHO IS UNDER THE AGE OF 5.

  • Correctly follow all instructions and safety requirements shown in this manual; otherwise, injury or death, especially for children, could result.

  • All inflatables are temperature sensitive, therefore never unfold or inflate in temperatures below 50°F (10°C).

  • Once inflated, make sure that the product does not come in contact with stones, gravel or other sharp objects which could puncture the inflatable.

To prevent premature material fatigue, refrain from exposing the product to unnecessary sunlight. Overexposure to sunlight may cause leakage.
While every attempt is made to embody the highest degree of protection in all equipment, we cannot guarantee freedom from injury. The user assumes all risk of injury resulting from use. All merchandise is sold on this condition, which no representative of the company can waive or change.

Repair patch instructions

For your convenience, a repair patch has been included to repair holes in the inflatable section.
Do not use the patch for holes or rips on the seam.
In the event of an accidental puncture, cut out a suitably sized patch, making sure you round the corners of your repair patch to avoid peeling. Make sure the area to be patched is clean and dry. Press patch firmly over the puncture. Do not inflate for 20 minutes. The repair patch should be applied by an adult.

Setup Instructions

  1. PLACEMENT DIAGRAM: Use on grass or carpeted area only, not on pavement or other hard surfaces. The lawn should be free of rocks, bumps, depressions, sticks, etc. This product should be set up in a location that has a minimum distance of 305 cm away from any freestanding structures or obstructions including houses, garages, fences, trees, playground equipment, and large rocks.

  2. Roll out this product. Inspect for holes, tears, or other damage.

  3. Open the water plug at the bottom of the target base. Use a garden hose to slowly fill the anchor water bag.
    NOTE: You must fill the water bags before inflating this product with air. The water plugs have a wide opening, as shown above.
    WARNING: Overfilling the water bags will cause damage to the product.
    NOTE: When filling the anchor water bags, do not fully insert the garden hose into the water plug. The hose may cause an increase of pressure in the anchor water bags and may cause it to burst. Instead, place the garden hose just outside the plug opening and allow the water to pour in.
    When full, insert and close the plug.

  4. Unplug the air valves to inflate this product with AIR.
    NOTE: For easy air inflation, use a manual air pump designed specifically for plastic inflatables.

  5. BY MOUTH: Squeeze the base of the valve, causing the inner flap to open before inflating.
    BY PUMP: Insert air pump nozzle into the valve. The air pump nozzle should be inserted deep enough to open the inner valve flap before inflating.
    Do not overinflate the item. Once the item is completely inflated, then insert the air valve plug to seal it shut.
    NOTE: Fill the product with air until it is firm and solid. If there is any training at the seams, the item is overinflated. If any seam begins to strain,  immediately stop inflation and release air to reduce the pressure until all signs of stress on the inflatable are gone. DO NOT use the product if there is straining at the seams. Use of an over-inflated item may result in serious injury, paralysis, or death.
    Inspect this product for rips, tears, or punctures. Do not use if damaged.

amotoys AXE Throw Challenge - fig 2| amotoys AXE
Throw Challenge - fig 3
---|---
amotoys AXE Throw Challenge - fig 4| amotoys AXE
Throw Challenge - fig 5
amotoys AXE Throw Challenge - fig 6

Use Instructions

HOW TO PLAY
Venture into the great outdoors of your own backyard with the Axe Throw Challenge™! Towering at 6 feet tall, this inflatable freestanding target features a self-sticking surface so your tosses really stick to their hit. The self-sticking inflatable axes are lightweight for a fun and safe way to play all summer long!
NOTE:

  1. Competent adult supervision is required at all times. Responsible adults should instruct children on the proper use of this toy.
  2. Remove all hard or sharp objects such as toys, buckles, keys, jewelry, watches, etc., from person and pockets.

amotoys AXE Throw Challenge - fig 11

After Use and Storage

  1. Make sure this product is completely free of grass, leaves, sand, twigs, dirt, etc. This will lengthen the life of this product.
  2. Drain this product and let it dry.
  3. Once the product is completely dry, carefully deflate and then roll it up.
    Store in a secure location away from children. Do not store it indoors or in a closed container until it is completely dry.
    NOTE: Store this product in a secure place, away from children, to prevent suffocation.

amotoys AXE Throw Challenge - fig 7| amotoys AXE
Throw Challenge - fig 9
---|---
amotoys AXE Throw Challenge - fig 10

amotoys AXE Throw Challenge - logo Manufactured by

Sverige, Norge, Denmark: AMO Toys AB, Garnisonsgatan 10, 25466 Helsingborg. Konsumentservice Sverige +46 72 202 61 42 / Kundeservice Norge +47 46520501 / Kundeservice Danmark +45 72170187. www.amo-toys.com. Finland: Amo OY, Ansatie 5, 01740 Vantaa/Vanda, www.amo.fi. Konsumentservice, puh./tel. +358 20163 0530. Keep this information

References

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals