Youpro Technology D605TX Wireless Microphone Transmitter User Manual
- June 4, 2024
- Youpro Technology
Table of Contents
Youpro Technology D605TX Wireless Microphone Transmitter
Product Introduction
Thanks you for choosing our products. This product is a smart wireless collar-
clip microphone that provides protessional on-site recording output. Plug and
play, no app required, Multi-purpose. It could be used for webcasting,
video,vlog, shooting prograrm interview, recording, video-teachin, conference
speech, KTV accompaniment and other OCcastios.
Wireless Microphone consisted of Transmitter and Receiver (PICS
HERE)
Function Introduction(Transmitter)
Function Introduction(Receiver)
Instruction
- Connect the receiver to the mobile phone;
- Long press power on/off;
- After the transmitter/receiver is turned on, it will automatically pair. After the pairing is successful, the indicator Will turn trom flashing to steady on. (Some devices need to be set before use. For details, refer to the corresponding device instructions)
- After the pairing is successful, you can switch the corresponding sound effects, Such as noise reduction, reverb, dodge and so on, through the function button.
- Mobile phone volume adjustment: short press+ switch, or short press+ switch, can adjust the broadcast volume of mobile phone;
- when use monitor headphone or webcasting, insert to transmitter monitor socket. 3.5MM studio headphone port & Type C sound cart,external Mic are supported.
- Please use the Fluffy Mic. Cover to avoid the nosie when outside and too close of the sound.
- Both transmitter & receiver has clip down the bottom, Please put in proper position when need.
- When the battery is low, the battery indicator LED flashes quickly, please charge in time.
- Charging with Type-C Cable,to connect power bank or battery charger.Charging: indicator lampP flashing.Full charged: indicator lampis always on.
This product supports charging bin, please purchase according to need.
Specification
Transmitter
Receiver
Other
FCC STATEMENT
15.19 Labelling requirements.
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
15.21 Information to user.
Any Changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment.
15.105 Information to the user.
Note: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmfül interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the cquipment off and on, the user is encouraged to try to correct the
interterence by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without restriction.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>