TRAXXAS Front Bumper/Winch Fairlead Installation Guide
- June 6, 2024
- Traxxas
Table of Contents
http://www.traxxas.com/manuals
Front Bumper/Winch Fairlead Installation Instructions –
Mercedes-Benz ® G 500 ® and G 63 ®
Covers Part #8868
Kit contents :
- Front bumper
- Winch fairlead
- 2.5x10mm cap head screws (6)
Tools needed:
- 2.0mm hex wrench
- Body scissors (part #3431 or #3432, sold separately)
Body Template 1:1
Body modification (Fig. A) :
Before installation of the new front bumper, the vehicle body will need
modification. Cut out the
body template above, and then place it on the front of the body as shown. Use
body scissors to cut
out the section as indicated.
CAUTION: RISK OF INJURY!
Use care with hobby knives, tapered reamers, and other cutting tools as they
are extremely sharp
and can cause severe injury, deep cuts, and/or punctures.
Remove the front skid plate and existing front bumper.
Remove the winch mount from the winch (part #8856, sold
separately) by removing the 2.5x20mm button-head cap screws. Discard these
screws.
Install 2.5x12mm cap screws (included with part #8855 winch kit, sold
separately) in the rear of the housing as shown prior to installation of the
winch on the new front bumper.
Attach the winch and the included fairlead to the new front
bumper using the supplied 2.5×10 cap screws (6). Install the new front bumper
and reinstall the front skid plate using the screws from step 2.
Completed
Installation
Mercedes-Benz®, G 500®, and
G 63® are trademarks of Mercedes-Benz/Daimler AG. All copyrights and
trademarks are used by Traxxas under license.
TRAXXAS.com
Traxxas, 6250 Traxxas Way, McKinney, TX 75070, Phone:
972-549-3000, Fax:
972-549-3011,
e-mail: support@Traxxas.com
KC2891-R00 Rev 201118
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>