CycleOps H2 Hammer Belt Replacement User Manual

June 6, 2024
CycleOps

CycleOps H2 Hammer Belt Replacement - logo H2/hammer belt replacement manual

Customer Service 800.783.7257 cycleops.com

CycleOps H2 Hammer Belt Replacement - fige18

Disconnect the power cord and remove the bicycle from the Hammer.
If necessary, remove the cassette and freehub from the trainer. It is easiest to remove the whole freehub assembly by removing the endcap with 5mm Allen for the QR endcaps and an adjustable wrench for all others.

CycleOps H2 Hammer Belt Replacement - fige2

Lay the trainer on its side on a mat or towel to prevent scratching. The drive side of the trainer is pointed up. Insert 5mm Allen key turning counterclockwise to remove endcap.

CycleOps H2 Hammer Belt Replacement - fige3

Remove the side cover by loosening the 5 smaller screws with a 1/8 Allen key, and the 2 larger screws with a T30 key turning counterclockwise.CycleOps H2
Hammer Belt Replacement - fige4

Lift the case of the Hammer to gain access to the tension screw, you can gain access to the tension screw port by opening up the leg.

CycleOps H2 Hammer Belt Replacement - fige5

Open leg to outward position.

CycleOps H2 Hammer Belt Replacement - fige6

Using the 5mm Allen Turn the tension screw counterclockwise.

CycleOps H2 Hammer Belt Replacement - fige7

You should be able to rock bolt freely from side to side.

CycleOps H2 Hammer Belt Replacement - fige8

Once the tension bolt is completely loosened you can remove the belt from the pulley wheel.

CycleOps H2 Hammer Belt Replacement - fige9

Slide the belt between the pulleys and remove the belt.

CycleOps H2 Hammer Belt Replacement - fige10

Slide the old belt out between the two pulleys.

CycleOps H2 Hammer Belt Replacement - fige11

To install the new belt slide the new belt between the two pulleys.

CycleOps H2 Hammer Belt Replacement - fige12

Gently pull the belt over the large pulley wheel.

CycleOps H2 Hammer Belt Replacement - fige13

Carefully spin the fl wheel clockwise while gently pushing the belt onto the fl y wheel.

CycleOps H2 Hammer Belt Replacement - fige14

The path for the belt is around the large fl wheel and then in between the two pulleys.

CycleOps H2 Hammer Belt Replacement - fige15

Tighten the tension screw.

CycleOps H2 Hammer Belt Replacement - fige16

Periodically rock the tension screw to make sure it is seated.

CycleOps H2 Hammer Belt Replacement - fige17

Check the distance between the two washers with the provided measuring gauge. It should be 3/4in.

CycleOps H2 Hammer Belt Replacement - fige18

Close the leg and install the case. Tighten down all the fasteners until snug. Reinstall the freehub. Once installed perform roll down calibration.
For a full warranty www.cycleops.com/support/warranty

CycleOps 5253 Verona Road Madison WI 53711 608-274-6550
800-783-7257 www.cycleops.com 28188 11/18

References

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals