hama 00200010 Universal USB-C Car Notebook Power Supply 70WU Instruction Manual
- June 6, 2024
- Hama
Table of Contents
00200010
niversal USB-C Car Notebook Power Supply
70w
Universal-USB-C-Kfz-Notebook-Netzteil
Operating Instructions
Explanation of warning symbols and notes
Risk of electric shock
This symbol indicates a risk of electric shock from touching product parts
carrying hazardous voltage.
Warning
This symbol is used to indicate safety instructions or to draw your attention
to specific hazards and risks.
Note
This symbol is used to indicate additional information or important notes.
Package contents
- Universal USB-C Car Notebook Power Supply Unit
- USB-C 2.0 Cable 3A
- These operating instructions
Safety instructions
- Use the product only for the intended purpose.
- Do not use the product in the immediate vicinity of heaters, other heat sources, or in direct sunlight.
- Only use the article under moderate climatic conditions.
- Do not use the product in areas in which electronic products are not permitted.
- Do not use the product in a damp environment and avoid splashing water.
- Do not short-circuit the battery of the opened terminal device. Thereisarisk of explosion.
- Protect the product from dirt, moisture, and overheating and use it in dry environments only.
- Do not drop the product and do not expose it to any major shocks.
- Do not operate the product outside the power limits specified in the technical data.
- Always pull directly on the plug when disconnecting the cable, never on the cable itself.
- Make sure that cables do not pose a tripping hazard or block emergency exits.
- Do not bend or crush the cable.
- As with all electrical products, this device should be kept out of the reach of children.
- Do not modify the device in any way. Doing so voids the warranty.
- Keep the packaging material out of the reach of children due to the risk of suffocation.
- Dispose of packaging material immediately in accordance with the locally applicable regulations.
- Ensurethereissufficient scope for heat dissipation and ventilation.
- When using this product, observe the applicable local traffic laws and regulations.
- Take care that components such as airbags, safety areas, controls, instruments, etc., and visibility are not blocked or restricted.
- Ensure that the product is securely mounted before every journey.
- Do not allow yourself to be distracted by the product when driving a vehicle. Always pay attention to the surrounding traffic and your environment.
- Make sure that the connected device meets the requirements for supply through class PS3 power sources. If there is any doubt, ask your device manufacturer.
Risk of electric shock
- Do not open the device or continue to operate it if it becomes damaged.
- Do not use the product if the charging cable, adapter cable, or power cable is damaged.
- Do not attempt to service or repair the product yourself. Leave any and all service work to qualified experts.
Start-up and operation
Note –mains voltage 12 –24V
Only operate the power supply unit on car electrical networks with a network
voltage of 12 –24V.
- Ensure that your notebook requires a supply voltage of 5V /9V/12V /15V /20V (+/- 1Volt).
- You can find this information on the original power supply unit or in your terminal device’s operating manual. If necessary, ask the dealer who supplied your terminal device or contact your terminal device manufacturer’s support service.
Warning
- Do not use the universal notebook power supply unit if you are unable to definitively determine your terminal device’s supply voltage.
- Ensure that the notebook’s total power consumption does not exceed the power supply unit’s rated output of 70 W.
- Failure to comply with this may cause damage to the universal notebook power supply unit and the connected terminal device!
Note the instructions in your device’s operating manual.
If these do not contain any instructions expressly to the contrary, proceed as
follows:
Note –Power Delivery
-
Plug &GO: no additional software required, simply plug in and start:
Thanks to Power Delivery/Thunderbolt™ 3, the voltage and power are adjusted automatically. -
Be aware that, for efficient and optimized charging, your terminal device must support the PD (Power Delivery)/TBT3 (Thunderbolt™ 3) function.
-
If you have a large number of PD/TBT3-enabled terminal devices with different firmware updates, it may be that the function is not fully supported.
-
Connect the USB-C cable to the power supply unit and your terminal device.
-
Then connect the mains connector to the car electrical system’s car socket.
-
The terminal device can now be used and switched on / charged.
Note regarding the car battery
- With some vehicles, it can happen that power continues to be supplied even though the ignition has been switched off.
- You should therefore disconnect the product from the car electrical system after switching the engine off to protect your car battery from being drained.
Note regarding the USB-A socket
You have the option of charging or operating USB devices from the power supply
unit’s USB socket, e.g. tablet PC, smartphone, etc. The maximum output current
from the USB socket is 2A.
Care and Maintenance
Note
Disconnect the product from the mains before cleaning.
- Only clean this product with a slightly damp, lint-free cloth and do not use aggressive cleaning agents.
- Ensure that no water is able to enter the product.
Warranty Disclaimer
Hama GmbH &CoKGassumes no liability and provides no warranty for damage resulting from improper installation/ mounting, improper use of the product, or from failure to observe the operating instructions and/or safety notes.
Technical data
Input voltage| 12 –24V DC
Output voltage /current| 5V 3A
9V 3A
12 V 3A
15 V 3A
20 V 3A
Max. output power| 70 W
USB-A 5| 5V 2A
Ambient temperature| 0°–40° C
Note on environmental protection:
After the implementation of the European Directive 2012/19/EU and 2006/66/EU
in the national legal system, the following applies:
Electric and electronic devices, as well as batteries, must not be disposed of
with household waste. Consumers are obliged by law to return electrical and
electronic devices, as well as batteries at the end of their service, live to
the public collecting points set up for this purpose or point of sale. Details
to this are defined by the national law of the respective country.
This symbol on the product, the instruction manual, or the package indicates
that a product is subject to these regulations.
By recycling, reusing the materials, or other forms of utilizing old
devices/Batteries, you are making an important contribution to protecting our
environment.
Hama GmbH &CoKG
86652 Monheim /Germany
Service &Support
www.hama.com
+49 9091 502-0
All listed brands are trademarks of the corresponding companies. Errors and
omissions excepted,
and subject to technical changes. Our general terms of delivery and payment
are applied.
00200010/07.21
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>