Hama Full-screen protective glass for Samsung Galaxy S8 Instruction Manual
- June 6, 2024
- Hama
Table of Contents
Hama GmbH &CoKG
86652 Monheim /Germany
Service &Support
www.hama.com
+49 9091 502-0
Operating Instructions
Thank you forchoosingaHamaproduct. Take your time and read the following
instructions and information completely. Please keep this instruction in a
safe place for future reference. If you sell the device, please pass these
operating instructions onto the new owner.
1. Explanation of Warning Symbols endnotes
Warning
This symbol is used to indicate safety instructions or to draw your attention
to specific hazards and risks.
Note
This symbol is used to indicate additional information or important notes.
2. Package Contents
- Protectiveglassfor display
- Microfibre cloth
- These installation instructions
Note
The screen protector glass is shipped with a carrier film. Only remove this
backing film when instructed to do so by these operating instructions.
Safety Notes
Warning
- Small splinters of glass can lead to injuries if touched. Dispose of the product immediately if it is damaged or splintered during application or use.
- Only touch the damaged or splintered production undamaged areas and the edge.
- Beverycarefulwhiledoing so, thoroughly wash your hands afterward and avoid contact with your face and eyes.
InstallationRequirementsand Preparations
- Select a room with as little dust as possible to perform the installation(for instance the bathroom).
- Use a clean, level, and flat surface with no cloth covering as a work surface.
- Check that the screen protector glass is positioned correctly. To check, place the protector glass on your screen and determine the correct direction for subsequent mounting. Openings for speakers, microphones, cameras, etc. must be kept free.
- Before attaching the protective glass, clean the screen as thoroughly as possible. Any contamination on the screen, for example, dust, fingerprints, or lint will be visible after the protective glass is attached and may negatively affect the adhesion.
Note
Amicrofibrecloth which has been lightly moistened with lukewarm water is
sufficient for the cleaning.
Warning
Do not clean using paper towels, kitchen tow also abrasive cleaning agents
under any circumstances. This will scratch or damage the surface of the
screen!
5. Attaching the Protector
- Remove the backing film using the pull tabs indicated from the adhesive side(1) of the protective glass.
- Pay attention not to bend the protective glass.
- Do not touch any exposed areas on the adhesive side of the protective glass.
- Place the protective glass adhesive side down onto the display. While doing so, make sure the protective glass is aligned with the outer edges of the display and that all the cutouts, such as the opening for the loudspeaker, match up.
- If the protective glass is positioned incorrectly, you can pull it off and repeat the procedure.
- Use a microfibre cloth to gently and uni firmly smooth the protective Glasson the display.
- Smooth any remaining air bubbles from the middle outwards using a microfibre cloth.
**Note**
Mostar bubbles will disappear after a short while since the protector glass
does not fully flatten out on the display until then. However, if these air
bubbles are due to dust, repeat the mounting procedure after a thorough
cleaning. Use strips of conventional clear cellophane tape for aiding
application and removal without touching the adhesive side of the protector
glass.
6. Warranty Disclaimer
Hama GmbH &Co. KG assumes no liability and provides snowarranty for damage resulting from improper installation/mounting, improper use of the product or failure to observe the operating instructions and/or safety notes.