MedPro Highlight for Bleach Wipes 760-200 Instruction Manual

: June 6, 2024
: MedPro

Table of Contents

MedPro Highlight for Bleach Wipes 760-200
TECHNICAL PARAMETERS
FUNCTION
HOW TO USE
STORAGE AND DISPOSAL
TROUBLESHOOTING
WARRANTY
CAUTION
MANUFACTURER INFORMATION
Read User Manual Online (PDF format)
Download This Manual (PDF format)

MedPro Highlight for Bleach Wipes 760-200

TECHNICAL PARAMETERS

Product: Highlight for Bleach Wipes| Models:

Highlight for Bleach Wipes kit: 760-200
Lid: 760-205
Cartridge: 760-210
4 in. Adapter: 760-214
9 in. Adapter: 760-219

---|---
Dimensions:

Highlight for Bleach Wipes kit – 13.4″L x 11.2″ W x 17.3″ H
Lid – 6.02″L x 5.06″ W x 4.75″H
Cartridge – 4.24″L x 3.31″W x 3.88″H
4 in. Adapter – Ø7.77″ x 9.15″H
9 in. Adapter – Ø8.90″ x 1.36″H

| Weight (approx.):

Highlight for Bleach Wipes kit – 6.6 kg
Lid – 662 grams
Cartridge – 550 grams
4 in. Adapter – 361 grams
9 in. Adapter – 132 grams

Rated Voltage: 9VDC (1.5VDC x 6)| Battery Capacity: 17.1Ah (2850mAh x 6)
Cartridge – Highlight Capacity: ≥ 270ml| Cartridge – Highlight Viscosity: 2-3cP

FUNCTION

Highlight for Bleach Wipes Lid (“Lid”) is a reusable product that dispenses disinfectant wipes colorized blue by Highlight for Bleach Wipes Cartridge (“Cartridge”) to improve visibility of surface coverage. The colour fades to colorless over time.
Highlight for Bleach Wipes Adapters (“Adapters”) enable Lids to be used with 9-inch bucket sized bleach wipes or with 4-inch canister sized bleach wipes.

HOW TO USE

Attach Lid directly to a wipe canister or Adapter.
- There are two Adapter sizes: the 9-in for bucket sizes and the 4-in for small canisters.
- 9-in Adapter instructions: remove the top from the bleach wipes bucket. Attach the Adapter to the bleach wipes bucket. Place the Lid on top of the Adapter.
- 4-in Adapter instructions: remove the top from the bleach wipes canister. Attach the Adapter to the bleach wipes canister. Place the Lid on top of the adapter.
Insert a Cartridge into the Lid.
- Each Cartridge is single use and is adequate for one bucket or two canisters of bleach disinfectant wipes.
Thread the first wipe though the Lid by opening the Lid using the two side latch buttons and ensure that the wipe is laying horizontally across the center of the rollers. Take care not to pinch the wipe when closing the Lid.
Press the Lid’s “Dispense Wipe” button to dispense colorized wipes. Wipes will advance as long as the button is pressed. To dispense a wipe, hold the button until you see a wipe perforation.
- When using a new Cartridge, the first wipes may appear white until the Cartridge begins to colorize wipes. Once colour is visible, open the Lid, place wipes back into container.
Immediately apply the wipe to the surface to be disinfected. Apply friction and adequately cover the entire surface with the blue colour.
- Use only on hard, non-porous surfaces such as laminates, stainless steel, hard plastics, vinyl, and glass. Avoid contact with fabrics, untreated wood, paper products, or other soft, porous surfaces.
Highlight will fade from blue to clear within several minutes.
- If any residual colour is left, the colour can be removed by a wet paper towel or bleach wipe.
When one bucket of bleach wipes or two canisters of bleach disinfectant wipes have been used to completion, remove the Cartidge from the Lid.
Detach the Lid or Adapter from the empty container of bleach disinfectant wipes. Repeat 3.1 through 3.8.
After 5 minutes of inactivity, bleach wipes will retract to prevent drying out of the wipes.
Highlight for Bleach Wipes is compatible with almost all sizes of healthcare and professional-grade bleach wipes. This chart provides common examples but is not a complete list.

Highlight for Bleach Wipes Compatibility

Common Example

| Example Specifications|

Compatibility

PDI Sani-Cloth Bleach Wipe Large Canister (75 ct)| Canister diameter: 5″
Wipe size: 6″ x 10.5″| No adapter required, attach Lid directly to canister
Clorox Healthcare Bleach Wipes (70 ct)| Canister diameter: 4″
Wipe size: 6.75″ x 9″| Utilize 4-inch adapter
| | Bucket diameter: 9″
Wipe size: 7.5″ x 15″|
PDI Sani-Cloth Bleach Wipe Pail (160 ct)| Clorox Healthcare Bleach Wipes Bucket (110 ct)| Bucket diameter: 9″
Wipe size: 12″ x 12″| Utilize 9-inch adapter
Clorox Healthcare Bleach Wipes (150 ct)| Canister diameter: 4″
Wipe size: 6″ x 5″| Not recommended

STORAGE AND DISPOSAL

Lid can be cleaned with a bleach wipe or a wet cloth.
Lid should be stored out of direct sunlight. Do not expose to extreme temperatures.
Cartridge should be stored above 6°C (42°F). in a dry place in the original container. Keep away from open flames, intense heat, or direct sunlight.
When Cartridge is empty, the battery pack may be removed from the underside of the Cartridge and batteries can be disposed based on workplace guidelines. Empty Cartridge can be disposed of in regular waste.
Do not attempt to open or disassemble Lid. Do not drop.
Use within 1 year of purchase.
Do NOT use with expired bleach wipes, refer to bleach wipe product label.

TROUBLESHOOTING

Troubleshooting 01

Problem

| Probable Cause|

Solution

---|---|---
No response when pressing Dispense Wipe Button on Lid.| Cartridge not properly inserted into or not making contact with Lid.| Remove Cartridge from Lid. Ensure Pogo Pins on Lid and Battery Contacts are clean and re-insert fully into Lid.
Lid not properly closed.| Ensure Lid is completely closed with the 2 Lid Latch- es (1 on each side of the Lid) engaged.
Lid Closing Switch is not working properly.| Open Lid and ensure the Lid Closing Switch is not damaged and can be depressed and spring back freely.
Battery power low.| Replace batteries in Battery Compartment (6 AA batteries required) or utilize new Cartridge.
Pressing Dispense Wipe Button runs motor but not dispensing wipe.| No wipe in the canister.| Replace with new Canister.
Wipe is not engaging with Rollers.| Open Lid and ensure wipe is placed on top of the Bottom Roller with 1-2 inch lead.
Pressing Dispense Wipe But- ton feeds out wipes but not dispensing any Highlight onto wipe.| No Highlight in the Cartridge.| Replace with new Cartridge.
| Cartridge is not installed correctly.| Remove Cartridge from Lid and re- insert.

Troubleshooting 02

Problem

| Probable Cause|

Solution

---|---|---
Pressing Dispense Wipe But- ton feeds out wipes slowly and a small amount of Highlight.| Battery power low.| Replace batteries in Battery Compartment (6 AA batteries required) or utilize new Cartridge.
Pressing Dispense Wipe Button when no wipe is present across the rollers causes Lid to dispense Highlight.| Door Sensor not sensing absence of Wipe.| Open Lid and ensure the Door Sensor can swing freely.
Pressing Dispense Wipe But- ton does not dispense wipe after a wipe retraction.| Wipe is not engaging with Rollers after wipe retraction.| Open Lid and ensure wipe is placed on top of the Bottom Roller with 1-2 inch lead.
Wipe does not retract after 5 minutes of inactivity.| Lid was opened during the 5 minute window.| The Lid must remain closed for 5 minutes after a Dispense Wipe Button press for the wipe retraction to occur.
Most of the colour is fading, but some colour residue is being left behind.| Inconsistent wiping technique and uneven disinfectant coverage.| Fold the wipe in half and wipe the surface with multiple passes to evenly and thoroughly distribute disinfectant coverage. Any colour residue left behind can be wiped away with a wet paper towel or another bleach disinfectant wipe.
The surface contains soil or residue, such as sticker residue.| Remove any soil, gross filth, or residue prior to apply- ing Highlight in order to achieve effective disinfection on surfaces.
Less than 50% of the colour is fading or not fading at all.| Bleach wipes are no longer at the right concentration of bleach (due to decay or expiration).| Test concentration with hypochlorite test strip (if avail- able) or switch to a new bucket or canister of bleach wipes using the same Lid and Cartridge.
Bleach wipes are not being used.| Confirm to make sure that sodium hypochlorite wipes are being used. Switch to a new canister or bucket of bleach wipes.

WARRANTY

A.M.G. Medical Inc. warrants the Highlight for Bleach Wipes Lid to be free from defects in workmanship and materials, under normal and intended use and conditions, for a period of one (1) year from the original invoice date. A.M.G. Medical Inc. will at its sole discretion during the warranty period repair or replace with new or refurbished product without charge.
Inspect the Lid, Cartridge, and packaging to verify no damage has occurred as a result of shipping and handling. Do not use the Device if the integrity of the packaging has been compromised or the Device appears damaged. In the event of damage, retain the package with the contents and notify the manufacturer.
Warranty limitations: this warranty does not include any condition resulting from other than ordinary wear or any use for which the product was not intended; any condition resulting from incorrect or inadequate maintenance or care; damaged caused by accident, abuse, misues, fire, liquid contact, earthquake, or other external cause; and damages incurred during transportation.

CAUTION

Keep out of reach of children. For professional use only.
This product is not a disinfectant. For use with Health Canada-registered bleach-based disinfectant wipes only. Not for use with semi-critical or critical medical devices.
The Lid and Cartridge should only be used by staff who are trained in using the Lid and Cartridge. The Lid should only be used with the Cartridge provided by A.M.G. Medical.
Avoid contact with skin, eyes, or clothing. Wear gloves and protective eyewear. Wash thoroughly with soap and water after handling and before eating, drinking, chewing gum, using tobacco, or using the toilet.
First Aid: If in eyes, hold eye open and rinse slowly and gently with water for 15-20 minutes. Remove contact lenses, if present, after the first 5 minutes and then continue rinsing eyes. Call a poison control center or doctor for treatment advice.