WINZO WZ5081 Elongated One Piece Toilet Installation Guide
- June 6, 2024
- WINZO
Table of Contents
WINZO WZ5081 Elongated One Piece Toilet
IMPORTANT!
PRODUCT IS FRAGILE. TO AVOID BREAKAGE AND POSSIBLE INJURY HANDLE WITH CARE
The toilet must be installed by a fully insured and licenced plumber only.
Also be sure the installation conforms to local plumbing and building
codes.
Check if all the fittings are complete and make sure the toilet is no crack before installation.
TOOLS REQUIRED FOR INSTALLATION
REMOVE OLD TOILET
Shut off main water supply prior to installation!
- Shut off water supply line. If you do not have shut-off valve near the toilet shut off main water supply line.
- Remove remaining water from tank and bowl with a sponge or towel..
- Disconnect and remove water supply line connected to the toilet’s tank.
- Remove old mounting hardware and old toilet. Be sure to plug floor waste opening to prevent escaping sewer gases
- Remove closet bolts from flange and clean away old wax, putty, etc. from base area.
NOTE: Mounting surface must be clean and level before new toilet is installed!
INSTALL NEW TOILET
-
In order for your new toilet to fit correctly, check the rough-in dimensions (Distance from finished wall to center of mounting bolt holes must be 12”.
-
The fill valve was disassembled before package due to the short tank. So please assemble the fill valve to the toilet before install the toilet. Inser the fill valve into the installation hole at the bottom of the tank. Then install the rubber and plastic washer (optional)and tighten the nut.
Note: Toilet seat could be assembled before step 3.
-
Inser 2 floor bolts inside of the toilet flange and slide the bolts through the holes and align bolts horizontaly.
-
Carefully turn the toilet upside down on some padding. Firmly press a new wax ring onto the circular recess around the outlet opening.
-
Turn the toilet upright and gently lower it into position over closet flange & bolts. With the toilet properly aligned, press down firmly on both sides of toilet rim to seat wax seal (CAUTION: Do not move toilet after the wax ring is set)
-
Install bolt cap bases, Washers,nut and bolt cap over the closet bolts via the opening holes on both side of bowl. Do not tighten the nuts. It may and will cause damage to the toilet’s ceramic base. Then cover the opening holes with supplied plastic cover.
-
Install the lever trip, connect the water supply line,and turn on the water. Flush several times, check for leaks.
-
If necessary, adjust the water level in the water tank. Turn the adjusting screw clockwise to raise the water or Turn the screw counter-clockwise to reduce water.
-
Make sure the refill tube is properly inserted into the overflow pipe of the flush valve. Refill tube should be positioned higher than water level.
-
Put the tank lid on the tank.
Install the toilet seat in accordance with detailed seat installation -
Apply the silicone around the base of the toilet. When the silicone is dry, check for leaks for the next several days
Toilet Seat Installation Instruction
-
Insert the fixing bolt set into the seat holes of pan.
-
Using a screwdriver to temporarily tighten the bolts. (Do not full tighten). Adjustability is required at this step in order to position the seat in following steps.
-
Place the seat vertically, align holes to pins and press down insert.
-
Close the toilet seat onto pan, adjust until the seat is located in a satisfactory position.
-
Push centre button to release the seat. Carefully lift the seat so that the postion of the seat will not shift,then firmly tighten the screws.
-
Place the cover caps over the fixing base. And put the toilet seat back on the pins.
CLEANING
The toilet seat may be removed for cleaning -depress two release buttons and
lift up.
Clean only with a soft cloth or sponge usingwarm water and mild soap or
detergent.
Do not use any abrasive cleaning materials.
Do not use any solvents or corrosive liquids.
Documents / Resources
|
WINZO WZ5081 Elongated One Piece
Toilet
[pdf] Installation Guide
WZ5081, Elongated One Piece Toilet
---|---