Marshall RS7-HR Control Distribution Box Installation Guide
- June 6, 2024
- Marshall
Table of Contents
Marshall RS7-HR Control Distribution Box
HARDWARE OVERVIEW
- Power Indicator
- Controller Input
- Connection refresh
- Output Connection
- RS232 / RS422 Selector
- Firmware Service Port
- DC Power Connection
RS7-HR CONNECTION
The RS7-HR can be set on a desk top or you can use the included 1RU rack ears to install a rack. Please note the following:
- Before connecting your equipment please select RS232 or RS422 on the back of the unit
- Connect your controller to the Input connection on the front of the RS7-HR using a Cat 5/6 cable
- On the back of the RS7-HR connect your Cat 5/6 cables from the RS7-HR to each camera (you may need optional CV620-CABLE-07 Adapters for RS232)
- You will now connect power to the RS7-HR, you will see a red indicator light appear on the front of the unit, now you will push the refresh button once
- If you disconnect a camera or add a camera you will need to push the refresh button again
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>