Bard 8612-065 Display Board Replacement Kit Instruction Manual
- June 6, 2024
- Bard
Table of Contents
Climate Control Solutions
SUPPLEMENTAL INSTRUCTIONS
8612-065 Display Board Replacement Kit
FIGURE 1
Remove 5-Pin Connector from Back of Display Board
FIGURE 2
Display Board Components
Overview
The 8612-065 display board replacement kit is for use with the MC5300/MC5600
Series controller. Using this
kit will replace a non-functioning touchscreen display. Installation
IMPORTANT: Bard recommends the use of personal grounding straps to prevent static electricity shorts to electronic controls.
-
Disconnect power to the controller by disabling power to all connected units.
-
Open the door of the controller and disconnect the 5-pin connector plugged into the back of the display (see Figure 1). Disconnect Ethernet cable connector too, if applicable. Be sure to use care when removing connectors to avoid damage to the plug or display port.
-
Remove the four (4) screws located on the back of the display. Be sure to support the display from the
front when removing screws. -
Separate the display back bezel from the display, make sure to support the display from the front, and carefully remove the display from the controller door.
-
The display board replacement comes with the front bezel attached. Align replacement display with holes in controller door and attach back bezel using four (4) screws.
-
Connect the 5-pin plug to the back of the display. Reconnect Ethernet cable, if applicable.
-
Power up the controller by reapplying power to all connected units. If the replacement display has been installed correctly, the Home Screen will appear on the display.
Bard Manufacturing Company, Inc.
Bryan, Ohio 43506
www.bardhvac.com
Manual: 7960-900
Supersedes: NEW
Date: 12-7-20
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>