AUTO JACK 125mm Dual Action Polisher DAP125 Owner’s Manual
- June 6, 2024
- AUTO JACK
Table of Contents
125MM DUAL ACTION POLISHER
DAP125
Owner’s Manual & Safety Instructions
WARNING: Read this manual before using this product.
Failure to do so can result in serious injury.
SAVE THIS MANUAL.
General Safety Warnings: Read all safety warnings, instructions,
illustrations, and specifications provided with this appliance. Failure to
follow all instructions listed below may result in electric shock, fire,
and/or serious injury.
Save all warnings and instructions for future reference.
The term “appliance” in the warnings refers to your mains-operated (corded)
appliance or battery-operated (cordless) appliance.
Work area safety
a) Keep the work area clean and well-lit. Cluttered or dark areas invite
accidents.
b) Do not operate appliances in explosive atmospheres, such as in the presence
of flammable liquids, gases, or dust.
Electrical safety
a) Appliance plugs must match the outlet. Never modify the plug in any way. Do
not use any adapter plugs with earthed (grounded)
appliances. Unmodified plugs and matching outlets will reduce the risk of
electric shock.
b) Avoid bodily contact with earthed or grounded surfaces, such as pipes,
radiators, ranges, and refrigerators. There is an increased risk of electric
shock if your body is earthed or grounded.
c) Do not expose appliances to rain or wet conditions. Water entering an
appliance will increase the risk of electric shock.
d)Do not abuse the cord. Never use the cord for carrying, pulling, or
unplugging the appliance. Keep cord away from heat, oil, sharp edges, or
moving parts. Damaged or entangled cords increase the risk of electric shock.
e) If operating an appliance in a damp location is unavoidable, use a residual
current device (RCD) protected supply. The use of an RCD reduces the risk of
electric shock.
Personal safety
a) Stay alert, watch what you are doing, and use common sense when operating
the appliance.
b) Ensure the switch is in the OFF position before disconnecting and picking
up or carrying the appliance.
Appliance use and care
a) Do not use the appliance if the switch does not turn it ON and OFF. Any
appliance that cannot be controlled with the switch is dangerous and must be
repaired.
b) Disconnect the plug from the source before making any adjustments, changing
accessories, or storing appliances. Such preventive safety measures reduce the
risk of starting the appliance accidentally.
c) Store idle appliances out of the reach of children and do not allow persons
unfamiliar with the appliance or these instructions to operate the appliance.
d) Maintain appliances and accessories. Check for misalignment or binding of
moving parts, breakage of parts and any other condition that may affect the
appliance’s operation. If damaged, have the appliance repaired before use.
Many accidents are caused by poorly maintained appliances.
| SYMBOL | DESCRIPTION |
|---|---|
| Read the manual before set-up and/or use. | |
| Do not dispose of household waste. | |
| Conforms to relevant safety standards. |
ASSEMBLING:
Attach the polishing mop head to the backing pad.
OPERATING:
Be sure the switch is in the OFF position.
MAINTENANCE:
Please maintain and clean the necessary parts i.e. brushes, bearings & gears.
|
---|---
MODEL| DAP125
ΦPOLISHING FOAM mm| 125/150
Φ BACKING PAD mm| 125/150
ΦORBITL mm| 9
POWER W| 750
R.P.M.| 2000-6400
WEIGHT kgs| 2.
SPEED CONTROL| •
PROTECTION CLASS| II
OPERATING VALTAGE| 230V-50HZ
Machine Diagram
Parts List
Spare Part List
No| Name| Qty| No| Name| Qty
1| Backing pad| 1| 32| Bearing shroud| 1
2| Epoxy spacer| 1| 33| Elastic collar| 1
3| Six angle output shaft| 1| 34| Cross pan head screw| 2
4| Cross pan head screw| 2| 35| Stator| 1
5| Bearing 696-2RS| 3| 36| Carbon brush| 2
6| Elastic collar| 1| 37| Cross pan head screw| 2
7| Counterbalance| 1| 38| Brush holder| 2
8| Cross pan head screw| 5| 39| Sping coil| 2
9| Counterbalance shroud| 1| 40| Nameplate| 1
10| Output shaft| 1| 41| Switch| 1
11| Woodruff key| 1| 42| Switch push rod| 1
12| Cross pan head screw| 4| 43| Body housing| 1
13| Front cover| 1| 44| Trademark| 1
14| Elastic collar| 1| 45| Pushrod| 1
15| Large gear| 1| 46| Cable plate| 1
16| Elastic collar| 2| 47| Cross pan head screw| 2
17| Bearing 696-2RS| 1| 48| Capacitance| 1
18| Cross pan head screw| 4| 49| Speed controller| 1
19| Gear housing shroud| 1| 50| Rear cover| 1
20| Gear housing shroud label| 1| 51| Plug| 1
21| Plastic screw| 2| 52| Cable shroud| 1
22| Self-lock pin| 1| 53| Cross pan head screw| 2
23| Self-lock pin coil| 1| 54| Power and brush indicator| 1
24| Split washer| 1| 55| Power and brush indicator label| 1
25| Gear housing| 1| 56| Wrench| 1
26| Small gear| 1| 57| Hand rest| 1
27| Bearing 6000-2RS| 1| | |
28| Bearing plate| 1| | |
29| Rotor| 1| | |
30| Magnetic ring| 1| | |
31| Bearing 607-2RS| 1| | |
| | | | |
| | | | |
| | | | |
Seller Details:
DECLARATION OF CONFORMITY
Ts TOOLSAVIE
Suppliers of quality hand and power tools to the trade
EC — Declaration of Conformity according to;
Machinery Directive 2006/42/Ec
Restriction of Hazardous Substances Directive 2011 / 65 / EU
Electromagnetic Compatibility Directive 2014130/Eu
We, Toolsave Limited, are located at Unit C, Manders Ind. Est., Old Heath
Road, Wolverhampton, WV1 2RP, United Kingdom, declare in exclusive
responsibility that the Dual Action Polisher meets the essential health and
safety requirements of the above-mentioned directives.
To ensure presumption of conformity, the product has been assessed for
compliance with the following directives and standards either in part or in
full.
Directive
Machinery Directive 2006/42/EC
RoHS 2 Directive 2011 /65 / EU
Directive. 2011;65fEU
Electromagnetic Compatibility
Directive 2014/30/EU| Requirements and/or Standards applied
EN 61029-1:2009+A11:2010
EN 61029-2-1A:2012+A11:2013
EN 55014-1:2006/A22011
EN 56014-2:1997/A2:2008
EN 61000-3-2:2014
EN 61000-3-11:2000
---|---
TCF reference no. : DAP125
Name: Bill Evans
Title: Company Director
Signature:
12/08/2020
TOOL SAVE
UNIT C MANDERS INDUSTRIAL ESTATE
WOLVERHAMPTON WV1 2RP
Documents / Resources
| AUTO
JACK 125mm Dual Action Polisher
DAP125
[pdf] Owner's Manual
AUTO JACK, 125mm, Dual Action, Polisher, DAP125
---|---