WaterSentinel WSS-1 Refrigerator Filter Installation Guide
- June 6, 2024
- WaterSentinel
Table of Contents
WaterSentinel WSS-1 Refrigerator Filter
-
Locate existing filter and remove it by turning it counter clockwise as shown in the graphic.
-
Holding new filter in your hands, carefully remove the packaging and sanitary end-cap from the new filter.
-
Locate the Start arrow found at the top of the instruction label on the back side of the filter. Align the Start arrow with the arrow on the refrigerator filter head.
-
Apply slight upward pressure and rotate the filter clockwise until the Stop arrow on the front of the filter label is aligned with the arrow on the refrigerator filter head. Ensure filter is fully installed in refrigerator head a full 1/4 turn. This is required to activate the internal valve inside the refrigerator. If the filter is not turned a full 1/4 turn the valve will not fully open and may cause the water flow to be slow, or even cause the valve to make a chattering noise during use.
-
Dispense water into glass looking for good water flow. If flow is slow, remove and reinstall filter ensuring that the filter is a full 1/4 turn.
NOTE: Initial flow rate may be slower than expected. Full flow rate should be restored within 24-36 hours. -
Check filter one more time for any leaks.
-
Reset the filter replacement indicator light by holding down the Ice Type button and the Child Lock (or Moisture Control) button simultaneously for 3 seconds.
Specifications
Flow Rate: | .5 gpm (1.89 lpm) |
---|---|
Operating Temperature: | 33°-100°F (0.6°-38°C) |
Operating Pressure: | 30-100 psi (207-689 kPa) |
Life: | 6 Months or 300 gallons (1,136 liters) |
For further questions or assistance please
call866-218-8473.
Warning: To reduce the risk of property damage from water leakage, the
filter bypass plug MUST be used when a filter replacement cartridge is not
installed. For cold water applications only. Do not use with water that is
microbiologically unsafe or of unknown quality without adequate disinfection
before or after the system. Protect from freezing. REPLACE FILTER EVERY 6
MONTHS, OR IF BAD TASTE OR ODOR OCCUR.
Installation shall comply with applicable state and local regulations.
The risk associated with small parts can cause choking if swallowed.
Keep children away from small parts during the replacement of the water filter.
Aquamor, LLC, 42188 Rio Nedo, Temecula, CA
www.watersentinelfilters.com
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>