STUSB1602 Software Library for STM32F446 User Guide
- June 6, 2024
- ST
Table of Contents
STUSB1602 Software Library for STM32F446 User Guide
Introduction
This document provides an overview of the STUSB1602 software package enabling USB PD stack with NUCLEO-F446ZE and MB1303 shield
SOFTWARE
STSW-STUSB012
| STUSB1602 software library for STM32F446
IAR 8.x
| C-code compiler
HARDWARE
NUCLEO-F446ZE
| STM32 Nucleo-144 development board
P-NUCLEO-USB002
| STUSB1602 Nucleo Pack containing MB1303 shield (Nucleo expansion board to be plugged on NUCLEO-F446ZE)
SW library set-up
-
Download the STUSB1602 software package by searching STSW-STUSB012 from www.st.com home page:
-
Then click on “Get Software” from either the bottom or top of the page
-
Download will start after accepting the License Agreement, and filling contact information.
-
Save the file en.STSW-STUSB012.zip on your laptop
and unzip:
-
The package contains a DOC directory, ready-to-use binary files, associated projects and compliance reports
Suggested Hardware requirements
The software library has been optimized to quickly compile on the NUCLEO-
F446FE development board stacked with MB1303 expansion board (from P-NUCLEO-
USB002 package).
MB1303 is composed of 2 Dual Role Ports (DRP) USB PD capable receptacles (form
factor not optimized)
-
NUCLEO-F446ZE
-
MB1303
NUCLEO-F446ZE Hardware set-up
Software package Overview
The software library includes 8 different software frameworks (+ 3 without RTOS) already optimized to address most common application scenario:
|
Project
|
Typical Application
---|---|---
#1
| STM32F446_MB1303_SRC_ONLY(*)| Provider / SOURCE (power management)
#2
| STM32F446_MB1303_SRC_VDM| Provider / SOURCE (power management)
+ extended message support
#3
| STM32F446_MB1303_SNK_ONLY(*)| Consumer / SINK (power management)
#4
| STM32F446_MB1303_SNK_VDM| Consumer / SINK (power management)
+ extended message support + UFP support
#5
| STM32F446_MB1303_DRP_ONLY (*)| Dual Role Port (power management) + dead battery mode
#6
| STM32F446_MB1303_DRP_VDM| Dual Role Port (power management) + dead battery
mode
+ extended message support + UFP support
#7
| STM32F446_MB1303_DRP_2ports| 2 x Dual Role Port (power management) + dead
battery mode
+ extended message support + UFP support
#8
| STM32F446_MB1303_DRP_SRCING_DEVICE| Dual Role Port requesting PR_swap when attached in Sink or DR_swap when attached in Source
- by default, all projects are packaged with RTOS support
- project annotated with a (*) are available with and without RTOS support
For more details, please check Firmware Package documentation:
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>