RENESAS FPB-RA2E1 Fast Prototyping Board User Guide

Quick Start Guide Renesas RA Family
FPB-RA2E1 Fast Prototyping Board

Introduction

The FPB-RA2E1 Fast Prototyping Board provides an entry point for evaluation, prototyping, and development with the RA2E1 MCU. Moreover, since this board incorporates an emulator circuit, you can use it for designing your own applications without needing to make further investments in tools. This product includes through-holes for pin headers that allow access to all MCU signal pins, allowing easy prototyping with a breadboard.

Package Contents

• FPB-RA2E1 Fast Prototyping Board (RTK7FPA2E1S00001BE
• Quick Start Guide (this document)

On-chip memory: 128-KB ROM, 16-KB RAM, 4-KB data flash memory
Board size| Size: 53 mm x 85 mm; thickness: 1.6 mm
Power-supply voltage| VCC: 3.3 V to 5.5 V. MCU operation voltage range 1.6 V to 5.5 V.
Power-supply circuit| USB connector: VBUS (5 V input); VBUS is converted to 3.3 V by LDO.
2-pin external power-supply header*’
Push switch| Reset switch x 1; user switch x 1
LED| Power indicator: green x 1, user: green x 2, ACT LED: green x 1
USB connector| Connector: Micro USB Type-B
Pmod TM connector| Connector: Angle type, 12 pins x 2
ArduinoTM connector| Connector: 6 pins x 1, 8 pins x 2, 10 pins x 1

The interface is compatible with ArduinoTM UNO R3.

MCU header.‘| Header: 32 pins x 2

This part is not mounted

Board Layout

Figure 1. FPB-RA2E1 Board Layout

Arduino Interface

Figure 2. FPB-RA2E1 Arduino Interface

Pmod Interface

The FPB-RA2E1 Fast Prototyping Board has two Pmod connectors for the Type 2A interface. Pmod 1 can support Type 6A.

7. Note on Using the Board
Before using this board, download the user’s manual from the website at renesas.com/ra/fpb-ra2e1, and check the full specifications.

http://www.renesas.com/ra/fpb-ra2e1

R20QS0023EG0100 Rev.1.00
Jun.17.21

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>