BOSE Videobar VB1 Display Mounting Kit User Guide

Videobar VB1 Display Mounting Kit
User Guide

INSTALLATION

1. Read the included Important Safety Instructions before continuing.
   WARNING: Install this bracket only if the display will be fixed in place on a wall or to a cart. Do not install this bracket on a display that will not be fixed in place, such as on a tabletop stand.
   WARNING: Ensure the wall-mount bracket or cart (to which the display will be installed) is rated for the additional weight of this display mounting kit and the Bose Video bar VB1.

2. If the display is already mounted on the wall, detach the display from its wall-mount bracket, and save the original hardware.

3. Insert the tab of each vertical bracket (B) to a slot of the horizontal bracket (A).
   Notes:
   • The brackets may be assembled so the VB1 is above or below the display.
   • The two bolts on the horizontal bracket (aligned with the hinged tabs of the VB1) must face upward when the installation is complete.
   • The flat side of the horizontal bracket may face toward or away from the VB1 as long as the two slots for the hinged tabs of the VB1 point downward.
   • The vertical brackets should be equally distant from the center of the horizontal bracket.
   • The vertical brackets should align with the mounting points of the display and the holes in the wall-mount bracket.

4. Use two of the included M4 screws (D) to attach the tab of each vertical bracket (B) to the horizontal bracket (A) (four screws total).

5. If the upper two mounting points of the display are more than 628 mm (24.7 in) above the bottom edge of the display, attach the extension brackets (C) to the vertical brackets (B) using four of the included M4 screws (D) (eight screws total). The extension brackets will extend the usable length of the vertical brackets up 140 mm (5.5 in).
   Notes:
   • The extension brackets should increase the length of the vertical brackets by equal amounts.
   • The holes in the center of each extension bracket should be aligned with the holes in the center of each vertical bracket.

6. Insert the hinged tabs of the VB1 into the two slots near the center of the horizontal bracket (A). Use an included M4 nut (E) to attach each hinged tab to the bolt in front of each slot.

7. Place the vertical brackets (B) (and extension brackets, if applicable) between the rear panel of the display and the wall-mount bracket of the display. Align the holes of the display, vertical brackets (or extension brackets), and wall-mount brackets, and (re)attach them using the appropriate hardware. (Make sure the bottom edge of the display is approximately aligned with the flange of the vertical brackets.)

©2020 Bose Corporation, All rights reserved.
Framingham, MA 01701-9168 the USA
PRO.BOSE.COM
AM864717 Rev. 00
November 2020

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>