Bard QPB36-V Plenum Box Installation Guide
- June 6, 2024
- Bard
Table of Contents
**Bard QPB36-V Plenum Box Installation Guide
**
Installation
The plenum box is designed for use with the Q-TECTM Series heat pumps. It is for use in free blow applications.
- Remove the center screw from each top side of the unit (see Figure 1 on page 2).
- Place plenum box on top of Q-TEC unit with the open side down and the grille facing the front of the unit.
- Make sure that the bottom offsets of the plenum box are inside the top of the Q-TEC unit flange as shown in Figure 1. The outside of the plenum box should be flush with the outside of the unit.
- Re-install the center screw in each top side of the Q-TEC unit. These screws will go through the clearance holes on the plenum box and hold it in place.
- Adjust louvers to obtain desired air distribution.
Model Number
| Front Grille Part Number|
Side Grille Part Number
---|---|---
QPBS36-V
| 7051-035|
7051-046
QPBS36-V-8
| 7051-073| 7051-046
QPBS36-X| 7051-035|
7051-046
QPBS36-X-8
| 7051-073| 7051-046
QPBS36-4| 7051-035|
7051-046
QPBS36-4-8
| 7051-073| 7051-046
QPBS49-V| 7051-045|
7051-046
QPBS49-V-8
| 7051-078| 7051-046
QPBS49-X| 7051-045|
7051-046
QPBS49-X-8
| 7051-078| 7051-046
QPBS49-4| 7051-045|
7051-046
QPBS49-4-8
| 7051-078| 7051-046
QPB36-V| 7051-035|
—
QPB36-X
| 7051-035| —
QPB36-4| 7051-035|
—
QPB49-V
| 7051-045| —
QPB49-X
| 7051-045|
—
QPB49-4| 7051-045|
—
Bard Manufacturing Company, Inc.
Bryan, Ohio 43506
www.bardhvac.com
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>