TKE RP00-CU Flow X Stairlift for Curved Staircases User Manual
- June 6, 2024
- TKE
Table of Contents
RP00-CU
Stairlift user’s manual
part of Call module
FCC and IC Declarations
Compliance statement Canada & FCC (part 15.19)
This device contains license-exempt transmitter(s)/receiver(s) that comply
with Innovation, Science and Economic Development Canada’s license-exempt
RSS(s) and complies with part 15 of the FCC Rules. Operation is subject to the
following two conditions:
- This device may not cause harmful interference.
- This device must accept any interference received, including interference that may cause undesired operation of the device.
Warning (part 15.21)
Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
Information to the User (Part 15.105 (b))
Note: This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Introduction
This manual has been derived from the host manual the RP00-CU stairlift. This document describes the use of the Call module as mounted in an RP00-CU stairlift¹. The Call module (CM) is an optional function of a stairlift. This option makes it possible to communicate via a landline with up to three pre- programmed telephone numbers, for example in case of an emergency. Incoming calls can also be accepted.
Making a call
- Press the yellow alarm button for 4 to 7 seconds. The dialing tone can now be heard.
- Release the alarm button. The light on the alarm button has now turned green.
- If the contact answers, you can communicate by speaking in the direction of the alarm button.
¹Note the Call module is identified with Manufacturing part number M/N 1060661 and a complete stairlift with RP00-CU.
Disconnecting
- Press the yellow alarm button for 4 to 7 seconds. The light on the alarm button turns off.
The call has now ended. It is also possible for the person being called to hang up.
Choosing the next number
If the connection to the first contact does not succeed, you can choose to go to the next pre-programmed number. This is done as follows:
- During the call, press the yellow alarm button once briefly. The next number will now be dialed.
NOTE
If the contact’s number redirects to voice mail, you must also briefly press
the yellow alarm button once to call the next number.
Accepting incoming calls
The landline is connected to the Call module. An incoming call can therefore
also be accepted while using the stairlift. 
When there is an incoming call, the Communication Module produces a ring tone.
Accepting the call is done as follows:
- Briefly press the yellow alarm button once. The connection is now established.
Speak in the direction of the alarm button to communicate.
The call can be ended by pressing the yellow alarm button for 1 second.
Error codes
| LED color | Sound | Cause |
|---|---|---|
| Flashing red | None | Not connected to a base station or no base station |
selected
Flashing red| Two short beep sounds, not repeating.| CM power supply is lost
or backup battery is charging
Flashing green| Two beep sounds, repeating every 2 minutes| The CM tries to
reconnect to the registered base station
When calling, flashing red| Two beep sounds, 1second pause, two beep sounds,
not repeating| No telephone numbers programmed
Green (after trying to call)| None| No telephone line present
For other questions, please contact your supplier.
Reference: 003 – 1060661 Call module user’s manual partially
Version: A.2
State: Released
Documents / Resources
| TKE
RP00-CU Flow X Stairlift for Curved
Staircases
[pdf] User Manual
1060661, ZAH-1060661, ZAH1060661, RP00-CU, Flow X Stairlift for Curved
Staircases
---|---
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>