SC INDUSTRIES GRANITE16 Hearing Aid User Manual
- June 6, 2024
- SC INDUSTRIES
Table of Contents
Charging Case Information
- Charging Case Battery Status LED
- green – fully charged
- blue – charging
- red – low battery
- off – not charging
- Hearing Aid Battery Status LED
- green – fully charged
- blue – charging
- flashing red – not inserted correctly
- off – not charging
- Special Note: When the Hearing aid is in the charger it will enter the low-power “deep sleep” mode.
Volume Dial
- rotate up – increase the volume until max is hit
- rotate down – decrease volume until min is hit
Program Button
- Press once to change to the next program
- when the max program is hit next button press rolls over to the first program
Special Switch Combinations
- press Program Button for 5s to enter the low-power “deep sleep” mode
- press & hold Program Button while rotating the Volume Dial down 10 times to initiate a hardware reset
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
– Reorient or relocate the receiving antenna.
– Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help
Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions:
- This device may not cause harmful interference, and
- This device must accept any interference received, including interference that may cause undesired operation.