Shenzhen Jizhiduomi Technology JD001 Combined Wireless Charger and Cup Warmer Instruction Manual
- June 6, 2024
- Shenzhen Jizhiduomi Technology
Table of Contents
Shenzhen Jizhiduomi Technology JD001 Combined Wireless Charger and Cup
Warmer
Model: JD001
Model Name: COMBINED WIRELESS CHARGER AND CUP WARMER
Product Description
This product is a smart wireless power bank that supports long-distance
wireless charging from 0.3 to 0.5 mm. It can be charged wirelessly and is
compatible with all devices (smartphones) with a built-in wireless receiver.
.It features functions such as over-voltage protection, over-current
protection, over-temperature protection, short-circuit protection and foreign
object detection. The product is widely used in offices, homes, restaurants,
conference rooms outdoor, etc.
Instructions for use
- Before installing the product, it is necessary to clean the installation area.
- After completing the previous step, connect the power supply. Coordinate the position by using the center circle. The best position is the center of the silicone circle. After adjusting to the best position, mark that position.
- Place it on top to use, or use it with a data cable.
- After the alignment is completed, the smartphone with a wireless charging function can be charged.
- Note: When the product is not in use, please turn off the power to avoid excessive/overheating.
Electrical Specifications:
Input voltage range | 5-12Vdc±0.5Vdc |
---|---|
Rated input voltage | 5V-12Vdc |
Working distance | 2mm-5mm |
Standby loss | < 1W |
Rated input current | 1.67A |
Input efficiency | 82% |
Working frequency | 115~205kHz |
Input current protection value
(not in power transfer mode)
| 2A
Input current protection value
(has entered power transmission mode)
| 2A
Coil current protection value
(not in power transmission mode)
| 5A
Coil current protection value
(has entered the power transmission mode)
| 5A
Working temperature protection value| 70℃
FCC WARNING
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Any changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation.
If this equipment does cause harmful interference to radio or television
reception,
which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following
measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
To maintain compliance with FCC’s RF exposure guidelines, This equipment should be installed and operated with a minimum distance of 20cm the radiator your body: Use only the supplied antenna.