ALLREMOTE TX-SL019 Wireless Remote Control for Dashboard Instructions
- June 6, 2024
- ALLREMOTE
Table of Contents
TX-SL019 Wireless Remote Control for Dashboard
Instructions
OVERVIEW:
REMOTE PROGRAMMING PROCESS :
- Switch off DC Power or disconnect from battery.
- Make sure there is NO other transmitter operating at the same time.
- Switch on DC Power, within 5 seconds press the Remote up ▲ and down ▼button once simultaneously.
- Searchlight will flash to acknowledge the Remote, connection has been made.
- To program the second Remote (up to 4 remotes may be used with the searchlight, programming a fifth will replace the first), within five seconds after the first Remote programmed, press the second Remote up and down button or repeat step 1.
INSTALLATION:
- OPEN UP
- SCREW the TX-SL019 on the Dashboard
****|
---|---
FCC INFORMATION
The Federal Communication Commission Radio Frequency Interference The
statement includes the following paragraph:
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful
interference in a residential installation.
This equipment generates, uses, and can radiate radio frequency energy and, if
not installed and used in accordance with the instructions, may cause harmful
interference to radio communications.
However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
- This device may not cause harmful interference, and
- this device must accept any interference received, including interference that may cause undesired operation.
RADIO FREQUENCY: 2.4GHz
*Wireless Remote Battery: AAA2pcs
Wireless Remote Operation Distance: 65M**
Documents / Resources
|
ALLREMOTE TX-SL019 Wireless Remote Control for
Dashboard
[pdf] Instructions
TXSL019, V78TXSL019, TX-SL019 Wireless Remote Control for Dashboard, TX-SL019
Wireless Remote Control for Dashboard
---|---