Alpha Group 858350 Terra Wheel Instructions

8+
US858350

INSTRUCTION
2.4 GHZ
INDOOR/OUTDOOR

CONTENTS

| • 1 X FIGURINE
---|---
| • 1 X HOVERBOARD
| • 1 X REMOTE CONTROL

• 1 X FIGURINE

REMOTE CONTROL FUNCTIONS

BATTERY CHARGING AND INSTALLATION

This toy contains batteries that are non-replaceable.

This toy is only to be connected to equipment bearing either of the following symbols:

| · Battery capacity: 3.7V, 2000 mAh|
---|---|---

The light on the USB will illuminate when inserted correctly. When your toy is fully charged, the light will turn off.

• REMOTE CONTROL

GET READY

1. Align the feet to match the studs on the board.
   Always carry TERRAWHEEL from the hoverboard.

2. Turn onTERRAWHEEL and remote control.Wait 1-2 seconds for them to pair. Power indicator on remote control will stop blinking when paired.TERRAWHEEL’s LED lights will light up solid when paired.

3. NOTE: Continuously blinking lights indicate that the batteries are low and should be recharged.

CAUTION: To avoid injury, keep the toy on the floor when operating.

DRIVING

1. Push the left joystick forward or backward. TERRAWHEEL will move in that direction.

2. Push the right joystick left or right. TERRAWHEEL will make 360° spins in that direction.

3. Use a combination of the left and right joysticks to move TERRAWHEEL in any direction.

4. Use a combination of the turbo switch and above operations to move TERRAWHEEL quickly in any direction.

STUNT

1. Press and release the stunt button. TERRAWHEEL will execute a preprogrammed quick turn.

2. Press and hold the stunt button for 2-3 seconds. TERRAWHEEL will execute a preprogrammed figure 8.

BALANCE ALIGNMENT

1. Position TERRAWHEEL on top of two objects of the same height.

2. Press and hold the stunt button and the turbo switch for 2-3 seconds. TERRAWHEEL will enter alignment mode and the LED lights will blink.

3. The LED lights will stop blinking when the alignment is completed.

CAUTION：
Hair entanglement may result if child’s hair comes in contact with moving parts of toy.
Adult supervision is required.

WARNING:
CHOKING HAZARD — Small parts.
Not for children under 3 years.

ALPHA GROUP CO., LTD.
Alpha Animation Industrial Area, Jinhong Road East & Fengxiang Road North,
Chenghai District, Shantou, Guangdong, P.R.China(515800)

ALPHA GROUP US, LLC
2100 E. Grand Ave.
Suite 500 El Segundo, CA 90245, USA
Tel : 844-303-8936
customerservice@alphagroup-us.com |
www.alphatoys.com

MADE IN CHINA
CONFORMS TO THE SAFETY REQUIREMENTS OF ASTM F963.
©2021 ALPHA All rights reserved.

Keep these instructions for future reference as they contain important information.

CAUTION

• Batteries are small objects.
• Replacement of batteries must be done by adults.
• Follow the polarity (+/-) diagram in the battery compartment.
• Promptly remove dead batteries from the toy.
• Dispose of used batteries properly.
• Remove batteries for prolonged storage.
• Only batteries of the same or equivalent type as recommended are to be used.
• DO NOT incinerate used batteries.
• DO NOT dispose of batteries in fire, as batteries may explode or leak.
• DO NOT mix old and new batteries or different types of batteries (i.e alkaline / standard).
• DO NOT use rechargeable batteries.
• DO NOT recharge non-rechargeable batteries.
• DO NOT short-circuit the supply terminals.
• Rechargeable batteries are to be removed from the toy before being charged.
• Batteries are only to be charged by adults or by children at least 8 years old.

• Charging unit to be used with the toy should be regularly examined for potential hazard, such as damage to the cable or cord, plug, enclosure of other parts and that in the event of such damage; the toy must not be used until that damage had been properly removed.

FCC Statement:

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions:

1. This device may not cause harmful interference, and
2. This device must accept any interference received, including interference that may cause undesired operation.

Note: Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject to the following two conditions: (1) This device may not cause interference, and (2) This device must accept any interference, including interference that may cause undesired operation of the device.
CAN ICES-3(B)/NMB-3(B)

IC warning statement:

This device complies with Industry Canada’s licence-exempt RSSs. Operation is subject to the following two conditions:

1. This device may not cause interference; and
2. This device must accept any interference, including interference that may cause undesired operation of the device.

Supplier’s Declaration of Conformity
47 CFR § 2.1077 Compliance Information
Product name: TERRAWHEEL
Model: 858350

Responsible Party – U.S. Contact Information
ALPHA GROUP US, LLC
13048 Valley Blvd,
Fontana, CA92335, USA
Tel : 844-303-8936

FCC Compliance Statement
This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions:

1. This device may not cause harmful interference, and
2. This device must accept any interference received, including interference that may cause undesired operation.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>