Shantou Yuetong Technology YT6601 Rechargeable car Instruction Manual
- June 6, 2024
- Shantou Yuetong Technology
Table of Contents
Please read the instruction manual carefully before use.
Please keep the packaging box and the instruction manual for future reference.
Safety instructions:
-Please use it under the close supervision of adults!
-Please do choose a safe place, do not use or play near the street.
-During use, keep fingers, hair, and lose objects away from tires, wheels, or motors.
Precautions for battery use:
- It is recommended to use an alkaline battery.
- Don’t recharge the non-rechargeable battery.
- Please remove the rechargeable battery from the toy car before recharging.
- A rechargeable battery can only be recharged under the supervision of an adult.
- Do not mix up the alkaline battery, standard battery (carbon-zinc battery) or rechargeable battery (nickel-cadmium battery).
- Do not mix up old and new batteries.
- Only use the same or equivalent battery as the recommended battery.
- The battery should be installed with the correct polarity.
- The power terminals must not be short-circuited.
- If the battery is loose, bend the contacts to make them tightly contact.
- Exhausted batteries should be removed from the toy and disposed of immediately; do not throw batteries into fire.
- If you want to place the product for a long time, please remove the battery.
- When you stop playing it, please remove the battery and clean the water on the surface.
- When playing crawlers, please pay attention to the objects on the lawn to avoid affecting the movement.
- It is recommended not to exceed 3 batteries in a single play.
- Since the speed of this car is faster than that of its peers, please turn off the remote control when changing the version.
- Regularly check the electrical components of the product for signs of damage; please do not use the product until the damage is properly assessed.
If the product fails, remove the battery for one minute, and then reinstall it. If the fault still exists, replace the battery with a new one. The battery can only be installed by an adult.
COMPONENT LIST
INSTRUCTIONS FOR BATTERY INSTALLATION
| REMOTE CONTROL CAR | REMOTE CONTROL |
|---|
1. Make sure the power switch is at the OFF position.
2. Use the screwdriver to unscrew.
3. Remove the battery compartment cover.
4. Install the battery as shown below:
- Connect the rechargeable battery of the battery pack as shown in the picture,
- The AA battery version must ensure that the battery is installed in the correct location.
5. Install the battery compartment cover and tighten the screws.| 1. Make sure the power switch is at the OFF position.
2. Use the screwdriver to unscrew.
3. Remove the battery cover.
4. Put the 2 x AA batteries into the battery compartment according to the polarity shown inside.
5. Replace the battery cover and tighten the screws.
REMOTE CONTROL
FCC statement
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Caution: Changes or modifications not expressly approved by the party
responsible for compliance could void the user’s authority to operate
the equipment.
NOTE: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses,
and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
–Reorient or relocate the receiving antenna.
–Increase the separation between the equipment and receiver.
–Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
–Consult the dealer or an experienced radio/TV technician for help.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>