SYNC LAB SCL03-01 Wireless Charging Alarm User Manual
- June 6, 2024
- SYNC LAB
Table of Contents
SYNC LAB SCL03-01 Wireless Charging Alarm
SYNC WIRELESS CHARGING ALARM CLOCK (SCL03)
Recharge your body and your devices with SYNC Wireless Charging Alarm Clock with 4 features included: LED night light, alarm clock, USB charging port and wireless charging pad.
USER GUIDE
-
Plug-in the USB from your USB power adaptor to the USB Type C socket on the device
-
For Wireless Charging – place your device (Capable for Wireless charging) on the charging panel, adjust the location until your device is charging
-
For Wired Charging – plug-in the USB cable to the USB Type A on the device and connect to your device
-
For Time Setting –
A. Press ‘M” button two times for adjust the time, Hour segment is flashing, press+/- to adjust
B. Press “M’ button one time and minute segment is flashing, press+/- to adjust
C. Press ‘M” again to complete
D. Long press”-” to switch between 12h or 24h -
For Alarm Setting –
A. Press “M’ button one time for adjust the alarm, Hour segment is flashing, press+/- to adjust
B. Press “M” button one time and minute segment is flashing, press+/- to adjust
C. Press ‘M” again to complete and Alarm is now ON
D. If you want to turn the alarm OFF, long press “M” and you will hear a short “Beep” and the alarm is OFF now
E. If you want to turn the alarm ON, either enter alarm setting again or long press “M ” until you hear a long “Beep” and the alarm is ON now -
For LED Night Light – Press the Touch button on the left side of the clock to turn the LED night light ON/OFF
PRODUCT SPECIFICATION
TECHNICAL SPECIFICATION
LIMITED WARRANTY
SYNCLABCO(“Company”) provides a limited warranty to the original retail
purchaser of this pro this product that should the product or any part thereof
proven defective in material or workmanship within l year from the date of
original purchase, such defects will be repaired or replaced. at the Company’s
option , without charge for the parts or labor.
For European Union only, Company will give a Limited Warranty of 2 years on
this product.
To view the complete warranty, please visit
WWW.synclab.co.
FCC ID:2AAWE-SCL03
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part15 of the FCC Rules. These limits are designed to provide reasonable protection agains tharmful interference in a residential installation. This equipment generates uses and can radiatera radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation .lf this equipment does cause harmful interference to radio or television reception , which can be determined by tuming the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio{TV technician for help
Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority lo operate the equipment.
This device complies with Part15 of the FCC Rules. Operation is subject to the following two conditions:
(l)this device may not cause harmful interference, and
(2)this device must accept any interterence received, including interference
that may cause undesired operation.
RF Exposure Warning Statements:
This equipment complies with FCC radiation e,exposure limits set forth for an uncontrolled environment. This equipment shall be installed and operated with a minimum distance 20cm between the radiator&body.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>