May Cheong Toy Products Fty 81762 Off-Road Go RC RTR Vehicle User Manual
- June 6, 2024
- May Cheong Toy Products Fty
Table of Contents
May Cheong Toy Products Fty 81762 Off-Road Go RC RTR Vehicle User Manual
Maisto Radio Control Vehicles
Warning! Not suitable for children under 36 months.Small parts. Choking hazard. Please keep this owner’s instruction manual for future reference. It contains important information. We reserve the right to improve/revise the product specifications without notice.
Warning! The Antenna wires are not to be inserted into socket outlets.
Contents
- RC Vehicle x 1
- RC Transmitter x 1
- Antenna Tube x 2
- Owner’s Instruction Manual x 1
Battery Requirements
- Vehicle: 4 X 1.5V “AA” LR6/R6 Batteries
- Transmitter: 2 X 1.5V “AK LR6/R6 Batteries
Battery installation
Battery installation for the Transmitter and Antenna Tube installation: (Refer to Diagram 1 & 2)
- Use screwdriver to loosen the screw on the battery cover and to open the battery cover. (Screwdriver is not included)
- Install 2 new 1.5V “AK LR61R6 batteries in the battery Compartment with correct polarity (+/-) as shown inside the Compartment.
- Install the battery cover and then tighten the screw on the battery cover.
- Insert antenna wire into the antenna tube. Then bend down the exposed wire and insert a cover to the top end of the tube.
Battery installation for the Vehicle and Antenna Tube installation: (Refer to Diagram 3 & 4)
- Switch the power OFF.
- Use screwdriver to loosen the screw on the battery cover and to open the battery cover. (Screwdriver is not included)
- Install 4 pieces new 1.5V “AA” LR6/R6 batteries with correct polarities (+1-) as shown inside the battery compartment.
- Install the battery cover and then tighten the screw on the battery cover.
- Insert antenna wire into the antenna tube. Pass the antenna tube through the hole in the car body. Tie a knot at the top end of the wire.
How to play
(Refer to Diagram 5, 6 & 7)
- Switch on the vehicle.
- Push forward the lever on the left side of the transmitter to drive the vehicle forward. Pull back the lever on the left side of the transmitter to drive the vehicle backward.
- Push the lever on the right side of the transmitter to the left to turn left. Push the lever on the right side ol the transmitter to the right to turn right
- if the vehicle does not run in a straight line, adjust the wheel alignment under the chassis.
- Turn the power switch of the vehicle to OFF position when not in play.
Performance Tips
- Do not drive the vehicle on grass. sand or go through water.
- Do not drive the vehicle in windy or rainy weather.
- Do not drive the vehicle into any hard object.
- Keep fingers, hair and loose clothing away from the vehicle.
- The operating range can be affected by a variety of factors:
- Weak transmitter or vehicle batteries.
- Interference from other items that emit radio frequency signals such as another R/C item on the same frequency. CB radios, cordless phones, high voltage transformers, etc.
- Outdoor usage is recommended in order to get optimal control range.
Battery use
- Alkaline batteries are recommended.
- Only batteries of the same or equivalent type as recommended are to be used.
- Do not mix alkaline. standard or rechargeable batteries.
- Do not mix old and new batteries or different types of batteries.
- Non-rechargeable batteries are not to be charged.
- Rechargeable batteries are only to be charged under adult supervision.
- Rechargeable batteries are to be removed from the product before they are charged.
- Be sure to insert batteries with correct polarities and always follow the battery manufacturer’s instructions.
- Remove all batteries from the product when not in use for long periods of time.
- Exhausted batteries are to be removed from the product.
- The supply terminals are not to be short-circuited.
- Disposo of batteries properly. Do not dispose of batteries in lire – it may cause them to explode or leak causing injury or damage.
- Battery change must only be made by adults.
Cautions
- Do not attempt to disassemble the products.
- Do not operate the vehicle with same frequency with other players in same location. This will interfere and cause the vehicle to lose control.
- Make sure the batteries are installed with correct polarity (+/-) as shown inside the battery compartment.
- Remove the package, take out all accessories and assemble the product before giving it to children to play.
FCC Label Compliance Statement
This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions
- This device may not cause harmful interference, and
- This device must accept any interference received, including interference that may cause undesired operation.
Note : This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Warning : Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
RSS-310 Compliance Statement:
This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation. Science and Economic Development Canada’s licence-exempt RSS(s). Operation is subject to the following two conditions:
- This device may not cause interference.
- This device must accept any Interference, including interference that may cause undesired operation of the device.
Troubleshooting
| Problem | Cause | Correction |
|---|---|---|
| No Function | Low battery level Battery polarities are reversed The wheels are | |
| obstructed by foreign ob;ects | Replace with new batteries Insert the batteries |
with correct polarities as shown on the battery compartment Remove foreign
objects on the vehicle i wheels
Drive Slow / Poor Turning Signal| Low battery level The wheels are obstructed
by foreign ob;ects| Replace with new batteries Remove foreign objects on the
vehicle I wheels
Poor distance control| Low battery level Strong interference of surroundings|
Replace with new batteries Move to a better location for playing
Environmental notes
The whole product also does not belong to household waste at the end of the
product life. You can return it at collection points for the recycling of
electronic and electronical instruments. The symbol on the item .instruction
manual. hangtag or packing is showing this clearly.
Materials should be recycled according to their respective markings. Recycling
of old devices or other re-use of materials contained therein represents an
important contribution to environmental protection.
Please ask at your local community for the correct collection point.
Please retain this sheet and address for future use, as they contain important
information.
Disposal of batteries
Batteries should not be disposed of in the household waste. As the consumer
you are legally obliged to return batteries containing harmful substances and
all other used batteries. You can hand in your old batteries at public
collection points in your area or wherever batteries are sold. You will find
these chemical abbreviations along with a crossed-out refuse bin on batteries
containing harmful substances:
Pb = Battery contains lead
Cd = Battery contains cadmium
Hg = Battery contains mercury
CE Declaration
Hereby, MAY CHEONG GROUP FRANCE S.A.S., declares that this equipment is in
compliance with the essential requirements and other relevant provisions of
directive 2014/53/EU.
Frequency: 27MHz
Transmitting frequency band: 26.957-27.283MHz
Max allowed transmitting power: <10mW
Frequency: 40MHz
Transmitting frequency band: 40.66-40.70MHz
Max allowed transmitting power: <10mW
The declaration of conformity may be consult at: MAY CHEONG GROUP FRANCE S.A.S.: Parc Ariane – Le Venus, 2 rue Helene Boucher, 78280 Guyancourt, France.
The full text of the EU declaration of conformity is available at the following internet address: www.maycheonggroup.com.hk/declaration-of- conformity