Berkeley BLUESLEUTH Bluetooth Skimmer Locator User Guide
- October 27, 2023
- Berkeley
Table of Contents
Berkeley BLUESLEUTH Bluetooth Skimmer Locator
Quick Start User Guide
| UNPACKING
BlueSleuth ships with a charging dock, AC adapter, omni-directional and
direction finding SMA antenna and receiver all in a hard carrying case.
---|---
| POWERING UP/DOWN
BlueSleuth only has one physical button on the front of unit. Press this white
button to power up and hold it down for 3 seconds to power down.
| CHARGING
BlueSleuth ships with an AC powered charging dock. Place unit in charging dock
and be sure the red LED on top of unit in ON. If red LED is not ON, BlueSleuth
is not being charged. Try adjusting BlueSleuth in dock until red LED is ON.
Charging takes approximately 4-5 hours. BlueSleuth runs approximately 16 hours
on a full charge. BlueSleuth may also be operated while it is charging.
BlueSleuth has smart trickle charging circuity that is always calibrating the
battery but if your battery runtime is noticeably short after a full charge,
you may need to manually calibrate the battery. Go to BATTERY under MAIN MENU
for more details and consult BVS support.
|
OPERATION
BlueSleuth contains 2 independent modules constantly scanning for all nearby
bluetooth and bluetooth low energy devices. When BlueSleuth pairs to a BT
device, the unit may begin to perform true direction finding of that device.
For BLE devices that do not allow for full connection or pairing, BlueSleuth
allows for basic signal strength measurement. When first scanning an area for
all nearby bluetooth devices, the included omni-directional antenna is
recommended. Once all nearby bluetooth devices have been detected, direction
finding can be performed by replacing the omni-directional antenna with the
directional antenna. For more information on typical detection ranges and
environments, see included BlueSleuth data sheet or consult your BVS sales
engineer.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>