ISOLED 114664 Sys-Pro Push Input Radio Output for Switch or Dimmer Receiver User Manual

October 27, 2023
ISOLED

ISOLED 114664 Sys-Pro Push Input Radio Output for Switch or Dimmer Receiver User Manual

Features

  • Apply to single color LED RF controller or RF dimming driver.
  • Connect with push switch to achieve on/off and 0-100% dimming function.
  • Adopt 2.4GHz wireless technology, remote distance up to 30m.
  • Each remote can match one or more receiver.
  • CR2032 button battery powered.

Technical Parameters

Input and Output

  • Output signal: RF 2( ) .4GHz
  • Working voltage: 3VDC CR2032 ( )
  • Working current: <5mA
  • Standby current: <2μA
  • Standby time: 2 years
  • Remote distance: 30m(Barrier-free space)

Safety and EMC

  • EMC standard (EMC): EN301 489,EN 62479
  • Safety standard(LVD): EN60950
  • Radio Equipment(RED): EN300 328
  • Certification: CE,EMC,LVD,RED

Warranty

  • Warranty: 5 years

Environment

  • Operation temperature: Ta: -30 O C ~ +55 OC
  • IP rating: IP20

Dimension

Dimension

Battery Installation

Battery Installation

Wiring diagram

Wiring diagram

Push switch function:

  1. Short press: Turn on/off light.
  2. Long press(1-6s): When light is on, increase or decrease brightness continuously.

Match Remote Control (two match ways)

End user can choose the suitable match/delete ways. Two options are offered for selection:

Use the controller’s Match key

Match:
Short press match key, immediately press the push switch.
The LED indicator fast flash a few times means match is successful.

Delete:
Press and hold match key for 5s to delete all match, The LED indicator fast flash a few times means all matched remotes were deleted.

Use Power Restart

Match:
Switch off the power, then switch on power again, then repeat the procedure again. After the second ON/OFF procedure immediately short press on/off key (single zone remote) zone key (multiple zone remote) 3 times on the remote. The light blinks 3 times means match is successful.

Delete:.
Switch off the power, then switch on power again, immediately short press the push switch 5 times. The light blinks 5 times means all matched remotes were deleted.

Safety information

  1. Read all instructions carefully before you begin this installation.
  2. When installing battery, pay attention to the battery positive and negative polarity. A long time without the remote control, remove the battery. When remote distance becomes smaller and insensitive, replace the battery.
  3. If no response from the receiver, please re-match the remote.
  4. For indoor and dry location use only.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals