Actions Microelectronics EZC-5201BS Wifi Dongle User Guide
- June 6, 2024
- Actions Microelectronics
Table of Contents
Wifi Dongle
Wifi dongle Quick Start Guide
Model: EZC-5201BS
Hardware/ WiFi driver installation
Please Visit www.ezcast.com to download driver and user manual.
Wifi dongle
Windows 10
Open your computer or laptop, plug the EZC-5201BS into USB port, then the WiFi driver will be installed automatically.
Windows XP/7/8
Plug the EZC-5201BS into the USB port of your computer,open “Device Manager”, browse drivers that download from ezcast.com.
2. Please click wireless icon in the lower right corner,choose the available WiFi router,enter router’s password and wait for the connection to be completed.
Bluetooth driver Installation
- Please visit www.ezcast.com to download the Bluetooth driver.
- Open this folder, click the Setup.exe to complete the installation.
Note: Because there is only one Bluetooth work on the same PC, if you need to use the Bluetooth function of this product, please make sure that the Bluetooth that comes with the PC is disabled.
Learn More
Visit www.ezcast.com for more information. Visit www.YouTube.com/EZCast for
video tutorials.
FCC Caution:
Any Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
IMPORTANT NOTE:
Note: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
–Reorient or relocate the receiving antenna.
–Increase the separation between the equipment and receiver.
–Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
–Consult the dealer or an experienced radio/TV technician for help.
FCC Radiation Exposure Statement:
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment.
ISEDC Warning This device complies with Innovation, Science, and Economic
Development Canada licence-exempt RSS standard(s). Operation is subject to the
following two conditions: (1) this device may not cause interference, and (2)
this device must accept any interference, including interference that may
cause undesired operation of the device.
The device is compliance with RF exposure guidelines, users can obtain Canadian information on RF exposure and compliance.
Specific Absorption Rate (SAR) information
SAR tests are conducted using standard operating positions accepted by the
FCC/IC with the equipment transmitting at its highest certified power level in
all tested frequency bands, although the SAR is determined at the highest
certified power level, the actual SAR level of the equipment while operating
can be well below the maximum value. Before equipment is a available for sale
to the public, it must be tested and certified to the FCC/IC that it does not
exceed the exposure limit established by the FCC/IC, tests for each phone are
performed in positions and locations as required by the FCC/IC. this equipment
has been tested and meets the FCC /IC RF exposure guidelines when used with an
accessory designated for this product or when used with an accessory that
contains no metal and that positions the handset a minimum of 5mm from the
body. Non-compliance with the above restrictions may result in violation of RF
exposure guidelines.