Lifeguard Press WCPSQ Wireless Charging Pad User Manual
- June 6, 2024
- Lifeguard Press
Table of Contents
Lifeguard Press WCPSQ Wireless Charging Pad
VB Charging Pad Manual
FRONT
SPECIFICATIONS
- Manufacturer Lifeguard Press, Inc
- Address 134 Beech Bend Rd. Bowling
- Green, KY 42101
- Input DC 5V/2A, 9V/1.67A
- Output SW/7.SW/lOW
- Quick charge QC3.0
- Conversion 2′.73%
- Material ABS
NOTE
- PLEASE DO NOT DISASSEMBLE THIS PRODUCT.
- PLEASE DO NOT USE THIS PRODUCT IN HIGH TEMPERATURES OR A DAMP ENVIRONMENTS. PACKAGING LIST
- THE CHARGING SURFACE CANNOT CARRY METAL MATERIALS SUCH AS IRON SHEETS, METAL PROTECTIVE SHELLS, ETC.
HOW TO USE THIS WIRELESS CHARGER
- CONNECT THE MICRO USB C ABL E INTO THE C HAR GING PORT.
- PLU G THE USB CONN ECTOR INTO THE QC3.0 POWER ADAPTER .
- CONNECT THE POWER ADAPTER TO A POWER OUTLET .
- PLACE THE WIRELESS CHARGING DEVICE IN THE CENTER OF THE CHARGING AREA TO START CHARGING.
LED INDICATORS INFORMATION
- POWER ON: BLUE LIGHT AND RED LIGHT FLASH TWICE
- STANDBY MODE: RED LIGHT
- CHARGING: BLUE LIGHT
- CHARGING ERROR: BLUE LIGHT AND RED LIGHT FLASHING
BACK
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
- This device may not cause harmful interference, and
- this device must accept any interference received, including interference that may cause undesired operation.
Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the
equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following
measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
The equipment should be installed and operated with minimum distance 20cm between the radiator and your body.