dreadbox Hysteria VCO Oscillator with Note Quantizer Module User Manual
- June 6, 2024
- dreadbox
Table of Contents
dreadbox Hysteria VCO Oscillator with Note Quantizer Module
Two tune modes are available:
Manual:
- Hold the Quantize Button for 3 sec .The button will start flashing.
- Press the button once. Then send 1V from your CV source and press the button.
- Send 4V from your CV source. Then press the button.
- Remove all patch cables from the module. Then press the button and wait for the tuning to be completed.
Auto:
- Hold the Quantize Button for 6 sec
- The button will start flashing. Remove all patch cables
- Hit the button. Wait for the autotuning to finish.
For more info check our youtube video “hysteria V1.1 tuning”
Useful Notes
-
Before tuning HYSTERIA, please let the module stabilize for about 2 minutes. Both tuning modes are saved once fully completed.
If tuning mode is entered by mistake, just hold the button for 3 sec, or reset the power supply. -
The Pulse Output can be used for syncing another oscillator.
-
You can tell if you have the V1 or V1.1 by the bottom PCB size. V1.1 will have a small PCB, about 1/3 of the panel size.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>