Mas Innovations Pvt MC-RGB-V1 RGB Module Instructions
- June 6, 2024
- Mas Innovations Pvt
Table of Contents
MC-RGB-V1 Bluetooth
controller instruction
Operation
- Press the button for 3 seconds to power on the controller, LED will be on and indicates battery remaining.
- The controller will power off when can’t detect Bluetooth connection over 1 minute after power-on, in this period needs to search and connect to the device via Bluetooth, default device name in Bluetooth connection is BR2262e-s
- LED will flash in Blue after being connected to the Bluetooth device
- After being connected to a Bluetooth device, it can send specific commands via APP to the controller for below activities: Read battery remaining default to read-only 100,66,33,0 Set LED Q’ty to be controlled (default as 12pcs)
-
To control LED to light on with fixed color
-
To control LED to change color with fixed mode.
-
To control each LED lighting color
-
To read Bluetooth device name and firmware number. 5. Press button when it’s with Bluetooth connection, LED will light in a different color to show different battery remaining:
High battery remaining >66%: light in Green
Medium battery remaining33% -66%: light in Yellow
Low battery remaining<33%: light in Red
When battery remaining is too low battery voltage<3.2V: Strobe in Red- Press the button for 5 seconds, Controller will power off.
Parameter
- Discharge voltage5V
- Standard power supply: 5V/Recommended
- Charging current300mA
- Sleep mode power off with battery connected power consum pt ion15uA
- Output power consumption determined according to lighting mode of externally inserted LED strip, Maximum peak value: 1A
FCC statement
This device complies with Part 15 of the Rules. Operation is subject to the
following two conditions: (1) This device may not cause harmful interference,
and (2) this device must accept any interference received, including
interference that may cause undesired operation.
Caution: Changes or modifications not expressly approved by the party
responsible for compliance could void the user’s authority to operate the
equipment.
NOTE: This equipment has been tested and found to comply with the limits
for a ClassB digital device, pursuant to part 15 of the Rules. These limits
are designed to provide reasonable protection against harmfulinterference in a
residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more
of the following measures:
–Reorient or relocate the receiving antenna.
–Increase the separation between the equipment and receiver.
–Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
–Consult the dealer or an experienced radio/TV technician for help.
Radiation Exposure Statement
The device has been evaluated to meet general RF exposure requirements. The
device can be used in portable exposure conditions without restriction.