TRiSTAR KA-5814 Convector Heater Instruction Manual
- June 6, 2024
- Tristar
Table of Contents
TRiSTAR KA-5814 Convector Heater Instruction Manual
Instruction manual
SAFETY
-
By ignoring the safety instructions the manufacturer can not be hold responsible for the
-
If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly qualified persons in order to avoid a
-
Never move the appliance by pulling the cord and make sure the cord can not become
-
The appliance must be placed on a stable, level
-
The user must not leave the device unattended while it is connected to the
-
This appliance is only to be used for household purposes and only for the purpose it is made
-
This appliance shall not be used by children aged less than 8 years. This appliance can be used by children aged from 8 years and above and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning use of the appliance in a safe way and understand the hazards involved. Children shall not play with the appliance. Keep the appliance and its cord out of reach of children aged less than 8 Cleaning and user maintenance shall not be made by children unless older than 8 and supervised.
-
To protect yourself against an electric shock, do not immerse the cord, plug or appliance in the water or any other liquid
-
WARNING: In order to avoid overheating, do not cover the
-
CAUTION: Some parts of this product can become very hot and cause Particular attention has to be given where children and vulnerable people are present.
-
Children aged from 3 years and less than 8 years shall only switch on/off the appliance provided that it has been placed or installed in its intended normal operating position and they have been given supervision or instruction concerning use of the appliance in a safe way and understand the hazards Children aged from 3 years and less than 8 years shall not plug in, regulate and clean the appliance or perform user maintenance.
-
Children of less than 3 years should be kept away unless continuously
-
Do not use the appliance with a programmer, timer, separate remote-control system or any other device that switches the heater on automatically, since a fire risk exists if the heater is covered or positioned
-
Do not use this heater in the immediate surroundings of a bath, a shower or a swimming
-
Please do not install the appliance close to curtains and other combustible This could cause a fire.
-
The heater must not be located immediately below a socket-outlet.
-
The heater needs to be installed so that the switches and other controls cannot be touched by a person in the bath or
PARTS DESCRIPTION
- Power switch
- Operational panel/ display
- Legs
- Remote
- On/ off button
- Infrared receiver for remote control
- Heat setting button
- Timer button
- Temperature decrease button
- Temperature increase button
- Fan button
BEFORE THE FIRST USE
- Turn the heater on its side and screw on the included legs with the supplied
- Place the device on a flat stable surface and ensure a minimum of 10 free space around the device. This device is not suitable for installation in a cabinet or for outside use.
- Put the power cable into the (Note: Make sure the
voltage which is indicated on the device matches the local voltage before
connecting the device. Voltage 220V-240V 50/60Hz)
When the device is turned on for the first time, a slight odour will occur.
This is normal, ensure adequate ventilation. This fragrance is only temporary
and will disappear soon.
USE
- Put the plug into a grounded outlet and switch on the device with the main power
- When switched on, the Operational panel will display the room
- The operational buttons are on both sides of the
- Press Power button to on/off the
- Press Infrared receiver button to switch on /off remote-control
- Press Wi-Fi button (with indication light) to connect the device to the
- Press Heat setting button to select between four ( 750W / 1250W / 2000W and Anti-frost mode.)
- Press Timer button to set the device on
- Press” + ” or ” – ” to set the
- Press Fan button to switch on/off the fan in the
- Never place objects on the heater, such as clothing or Never use the heater in the bathroom or other wet areas. The air outlets of the heater can be very hot.
Timer
- This model is fitted with a 24hr timer set using the button beside the display or by the remote control or by the
- Press the timer button once to increase the timer by 1 hour, until it reaches 24:00.
- The timer function is enabled in 5 seconds after the time is
- To switch off the timer, press the timer button once after it reaches 24:00.
Remote Control
- Press the Infrared receiver button on the operational panel to operate the device with a remote
- On/ Off
- Heat setting
- Fan
- Wi-Fi
- Temperature increase
- Temperature decrease
- Timer
Anti_frost mode
- When the room temperature is decreased below 5°C in stand-by mode, The device automatically switches to 2000W heating mode until the room temperature reaches 9°C.
CLEANING AND MAINTENANCE
- Before cleaning, unplug the appliance and wait for the appliance to cool
- Clean the appliance with a damp Never use harsh and abrasive cleaners, scouring pad or steel wool, which damages the device.
- Clean the two air outlets (above and below) by using a vacuum cleaner to remove dust from
ENVIRONMENT
This appliance should not be put into the domestic garbage at the end of its durability, but must be offered at a central point for the recycling of electric and electronic domestic appliances. This symbol on the appliance, instruction manual and packaging puts your attention to this important issue. The materials used in this appliance can be recycled. By recycling of used domestic appliances you contribute an important push to the protection of our environment. Ask your local authorities for information regarding the point of recollection.
Read More About This Manual & Download PDF:
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>