Hangzhou Roombanker Technology DSBC-150-1 Outdoor Waterproof Beacon User Manual
- June 6, 2024
- Hangzhou Roombanker Technology
Table of Contents
Hangzhou Roombanker Technology DSBC-150-1 Outdoor Waterproof Beacon
Product Introduction
DSBC-150-1 is an outdoor temperature and humidity RF sensor, Suitable for outdoor environment temperature and humidity detection. It has excellent function of ultra-low power consumption.
Product Specification
Product Name | Beacon sensor | Model No. | DSBC-150-1 |
---|---|---|---|
Protocol | Bluetooth 5.2 | Temp | -30~55′ C |
Humidity | 0~100 % |
B a ttery
Capacity
| 1500mAh| Distance| 50~2oom
Product Size
| ****
70mm40mm40mm
(main body)
| ****
Weight
| ****
130g
Product Overview
Directions For Installation
3M adhesive stickers
Step 1: Select the adhesive tape to stick to the back of the device, and
tear off the adhesive tape on the back of the beacon sensor;
Step 2: Just stick the beacon sensor to the surface of the object;
Screw fixing
Step 1 : Place the device in the corresponding position on the wall;
Step 2 : Fix the beacon sensor with screws;
Fixing with expansion screw
Step l : Drill holes in the corresponding positions of the wall,and plug
the expansion cap into the hole punching
positions of the wall;
Step 2 : Place the beacon sensor in the corresponding position and fix
it with expansion
screws;
Attention
- Being close to a metal object will interfere with the signal, causing the signal to be weaken.
- Note the distance between DSBC-060-2 and the receiver to guarantee the accuracy of receiving.
- Keep away from the corrosive objects.
- When installing, make sure that the sensor part is installed facing down.
FCC Warning
This device has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This device generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a
particular installation. If this device does cause harmful interference to
radio or television reception, which can be determined by turning the device
off and on, the user is encouraged to try to correct the interference by one
or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the device and receiver.
- Connect the device into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help
Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment
FCC Radiation Exposure Statement The antennas used for this transmitter must be installed to provide a separation distance of at least 20 cm from all persons and must not be co-located for operating in conjunction with any other antenna or transmitter.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>